Publicidad
Idiomas disponibles
Idiomas disponibles
To service the air cleaner, follow these steps:
1.
Loosen two screws and lift off cover.
Two Screws
_
....
Cover
Cartridge
Base .
_
I_
2.
Carefully remove air cleaner from base.
3.
Install clean (or new) air cleaner in base. Air
cleaner must fit securely in base.
4.
Place cover over air cleaner and tighten screws.
NOTE: You can purchase new air filter elements by
calling 1-800-366-PART.
Service
Spark
Pmug
Service the spark plug every 100 hours of operation or
yearly, whichever occurs first.
1.
Clean area around spark plug.
2.
Remove and inspect spark plug.
3.
Replace spark plug if electrodes are worn, or if
insulator is cracked or chipped.
4.
For replacement use either the standard resistor
spark plug, Champion RC12YC or the long life
platinum spark plug, Champion RC12PYP.
5.
Check electrode gap with wire feeler gauge and
set gap at 0.020 inches (0.50mm), if necessary.
6.
Install spark plug, tighten securely.
NOTE: You can purchase a new spark plug by calling
1-800-366-PART.
Carburetor
if you think your carburetor needs adjusting, see your
nearest Sears service center. Engine performance
may be affected at altitudes above 3000 feet. For
operation at higher elevations, contact your nearest
Sears service center.
Spark Arrester
Service
Your engine is not factory-equipped
with a spark
arrester. In some areas, it is illegal to operate an
engine without a spark arrester. Check local laws and
regulations. A spark arrester is available from your
nearest Sears service center. If you need to order a
spark arrester, please call 1-800-366-PART.
The spark arrester must be serviced every 50 hours to
keep it functioning as designed.
If the engine has been running, the muffler will be very
hot. Allow the muffler to cool before servicing the
spark arrester.
WARN NG
DO NOT touch
hot surfaces.
Allow
equipment
to coo! before
touching.
The pressure
washer
must be at least 5 feet from
structures
having
combustible
walls
and/or
other
combustible
materials.
Keep at least 3 feet of clearance
on all sides
of pressure
washer
for adequate
cooling,
maintenance
and servicing.
in the State of California
a spark arrester
is required
by law
(Section
4442 of the California
Public Resources
Code).
Other states may have similar
laws. Federal laws apply on
federal
lands. If you equip the muffler
with a spark arrester,
it must be maintained
in effective
working
order.
Remove
spark
arrester
screen
for
cleaning
and
inspection.
Replace
if screen
is
damaged.
Air Coo_ing
System
Over time debris may accumulate in cylinder cooling
fins and cannot be observed without partial engine
disassembly.
For this reason, we recommend you
have an authorized Sears service dealer clean the
cooling system per recommended intervals (see
"Maintenance Schedule" on page 15). Equally
important is to keep top of engine free from debris.
See "Clean Debris".
18
Publicidad
