Craftsman 580.752810 Instrucciones De Uso página 6

Yourcleaning system requires someassembly a ndis
readyforuseonlyafterit hasbeenproperly serviced
withtherecommended oil andfuel.
If you haveanyproblemswith the assemblyof
your pressurewasher,pleasecallthe pressure
washerhelplineat 1-800-222-3136.
iMPORTANT: Anyattempt t o runtheenginebefore it
hasbeenserviced withthe recommended oilwinresult
in an engine failure.
REMOVE PRESSURE WASHER
FROM CARTON
1. Slice two corners at the end of carton from top to
bottom so the panel can be folded down flat.
2. Remove hose reel box, fillers, and parts bag
shipped with cleaning system.
3. Remove spray gun, nozzle extension, and engine
oil from fillers.
4. RoN cleaning system out open end of carton.
5. Check carton for additional loose parts.
CARTON CONTENTS
Check aN contents. If any parts are missing or damaged,
can the pressure washer helpNne at 1-800-222-3136.
Main Unit with Chemical Reservoir Assembly
Handle
Accessory Tray
Hose Reel Components
High Pressure Hose
Spray Gun
Nozzle Extension with Quick Connect Fitting and
Tip Holder
• Oil Bottle
• Parts Bag (which includes the following):
• Owner's Manual
• Owner's Registration Card
• Bag containing 4 multi-colored ProjectPro
TM
nozzles
• Fresh Start
TM
Fuel Cartridge
• Handle Fastening Hardware Kit (which includes):
• Carriage Bolts (2)
• Plastic Knobs (2)
• Tree Clips (4)
Become familiar with each piece before assembling the
pressure washer. Identify all contents with the iNustration
on page 5. If any parts are missing or damaged, call the
pressure washer helpNne at 1o800o222o3136.
ASSEMBLING CLEANING SYSTEM
Your Craftsman cleaning system will need assembly
before operation:
1. Attach handle to main unit.
2. Attach hose reel to handle as shown on page 5
according to instruction sheet included with hose reel.
3. Add oil to engine crankcase.
4. Add fuel to fuel tank.
5. Connect high pressure hose to spray gun and pump.
6. Connect water supply to pump.
7. Attach nozzle extension to spray gun.
8. Select/attach quick connect nozzle to nozzle
extension.
Attach Handle
1. Place handle assembly onto handle supports
connected to main unit. Make sure holes in handle
align with holes on handle supports.
I
\ Handle '
Align Holes _,_/'/>
¢i Handle /
// Supports /
NOTE: It may be necessary to move the handle
supports from side to side in order to align the handle
so it will slide over the handle supports.
2. Insert carriage bolts through holes from outside of
unit and attach plastic knob from inside of unit.
Tighten by hand.
3. Place accessory tray over holes on handle
(viewing from front of unit). Push tree clips into
holes until they sit flat against accessory tray.
/
/
.
.... // t
Insert multi-colored ProjectPro
TM
nozzles and
other supplied accessories in spaces provided in
accessory tray. See "How to Use Accessory Tray".
Attach Hose Reel
Attach hose reel to handle as shown on page 5
according to instruction sheet included with hose reel.
NOTE: There may be small tube adapters included
with the hose reel kit that is not used on this model.
IMPORTANT: You must take the hose off the reel
when operating your pressure washer. The reel is for
hose storage purposes only.