Publicidad
Idiomas disponibles
Idiomas disponibles
Cleaning
and AppRying
Detergent
IMPORTANT:
Use detergents
designed
specifically
for pressure
washers.
Household detergents could
damage the pump.
Up to three (3) different solutions can be carried with
the cleaning system at one time. To apply detergent
follow these steps:
1.
Prepare detergent solution as required by
manufacturer.
Fill chemical reservoir(s) with
prepared solution as needed. Label tanks with
provided tank labels.
Pour detergent into one of
the tanks labeled A, B, C.
System Rinse
Reservoir
2.
Rotate the DialoAoCleaner
TM
selector knob to letter
corresponding to desired reservoir.
NOTE: Each chemical reservoir holds two quarts.
3.
Make sure black ProjectPro
TM
cleaning detergent
nozzle is installed.
NOTE: Detergent cannot be applied with the high
pressure nozzles (Yellow, Orange or Red).
4.
Make sure garden hose is connected to water inlet
and water supply is turned on. Check that high
pressure hose is connected to spray gun and
pump; start engine.
i
CAUTION
• Starting the engine without all the hoses connected and
without the water turned ON will damage the pump.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
5.
Apply detergent
to a dry surface,
starting
at lower
portion
of area to be washed
and work upward,
using long, even, overlapping
strokes.
6.
Allow detergent
to soak in between
3-5 minutes
before washing
and rinsing.
Reapply
as needed
to
prevent
surface
from drying.
DO NOT allow
detergent
to dry on (prevents
streaking).
Pressure
Washer
Rinsing
After detergent is applied, scour the surface and rinse
it clean as follows:
1.
Apply trigger lock to spray gun.
2.
Remove black ProjectPro
TM
cleaning detergent
nozzle from nozzle extension.
3.
Select and install desired ProjectPro
TM
nozzle, as
described in "How to Use ProjectPro
TM
Nozzle
System".
4.
Keep spray gun a safe distance from spray
surface.
WARNING
.
.
Keep spray nozzle between 8 to 24 inches away from
cleaning surface.
Operate this unit on a stable surface.
Be extremely careful if you must use the pressure
washer from a ladder, scaffolding or any other relatively
unstable location.
Firmly grasp spray gun with both hands when using high
pressure spray to avoid injury if gun kicks back.
Apply
a high pressure
spray to a small area and
then check the surface
for damage.
If no damage,
proceed
to step 6.
Start at top of area to be rinsed,
working
down
with same
overlapping
strokes
used for cleaning.
Rinse System
After
Every
Use
It is imperative that the detergent dispensing system
be rinsed after each use to prevent clogging or leaks:
1.
Fill System Rinse reservoir with clean water.
2.
Before disconnecting water supply, start your
cleaning system.
3.
Make sure black ProjectPro
TM
cleaning detergent
nozzle is installed.
4.
Rotate the DialoA-Cleaner
TM
selector knob to letter
corresponding to System Rinse tank. As clean
rinse water is drawn through the system, continue
the flow until no detergent foam is observed.
5.
Rotate the D{al-A-Cleaner
TM
selector
knob to
the OFF position
when finished
to prevent
chernica_ leakage.
12
Publicidad
