EMS AIR-FLOW MASTER PIEZON Instrucciones De Empleo página 161

TROUBLESHOOTING
Symptom
The unit does not start or stop
The foot pedal does not activate the unit
The unit is still activated when the foot
pedal is released
User interface displays an error: there
LV RQH DFRXVWLF VLJQDO DQG DOO /('V DUH
blinking
The handpiece does not remain on the
magnetic support
The handpiece does not hold on the
handpiece cord
1R XOWUDVRXQG RVFLOODWLRQV RU LQVXI¿FLHQW
power
,QVXI¿FLHQW OLJKWLQJ RI WKH KDQGSLHFH
116
All manuals and user guides at all-guides.com
6ROXWLRQ
‡ Check the electrical connections and power supply at the mains
‡ Check the fuses on back panel
‡ &KHFN PDLQ VZLWFK IXQFWLRQ DW OHDVW RQH /(' PXVW EH YLVLEOH RQ DGMXVWPHQWV DQG ZRUNLQJ PRGH DUHDV
‡ The unit is in "standby" mode, tap on any sensitive zone to exit standby
‡ Send the unit to an authorized EMS Repair Center
‡ Check that the foot pedal is properly connected
‡ Replace the foot pedal
‡ Send the unit to an authorized EMS Repair Center
‡ The foot pedal is active, check for jam at foot pedal
‡ The switch in the pedal is blocked. Turn the unit off at the power switch
‡ Replace the foot pedal
‡ Send the unit to an authorized EMS Repair Center
‡ Powder chamber pressure is too low or too high
‡ The air or liquid regulator is switched off
‡ Foot pedal and purge commands are not recognized by system. Check connections
‡ Install the magnetic support on a metallic part of the unit
‡ The support is demagnetized
‡ Replace magnetic support
‡ Check for presence of the O-ring seal and replace if necessary
‡ Replace the handpiece
‡ Replace the handpiece cord
‡ Send the handpiece and the handpiece cord to an authorized EMS Repair Center
‡ Make sure that the Piezon instrument is correctly tightened
‡ Check the wear of the instrument and replace it if necessary
‡ Check the connections between the unit, the handpiece cord and the handpiece
‡ Dry the connectors of the handpiece cord and of the handpiece
‡ Check the connection of the foot pedal
‡ Check the settings and the working mode
‡ Check that when the handpiece is lifted from its support, the control lamps of the bottle holder are turned on; if it is not the
case, send the handpiece to an approved EMS repair center
‡ Replace the handpiece cord and/or the handpiece
‡ Send the unit to an approved EMS repair center
‡ Replace the light guide
Cont. next page