Low Battery Indicator - Arregui SUA Manual Del Usuario

• Press «ENTER».
• Enter the valid user or master code and press "ENTER".
• Enter "000" ("00"as the 2 digits for the OD period (opening
delay time) and "0" as the digit for the OW (opening window).
• Press "ENTER".
For example, enter "000" to cancel the OD and OW.
5. TURN THE SOUND ON/OFF
• Press "ON".
• Press "ENTER".
• Press "5".
• Press "ENTER".
• Enter the current master code and press "ENTER".
V ANCHOR (ANCHOR BOLT)
Drill a hole in accordance with the table.
Clean the hole with a brush.
Use a hammer to install the anchor.
Screw the anchor into the wall until it is steady.
T
T

6. LOW BATTERY INDICATOR

When the battery is low, the light turns red and the safe will
beep 5 times. In this case, it is necessary to change the
batteries.
7. MAINTENANCE
Periodically (every 6 months) check the condition of the battery
compartment to detect possible signs of rust, sulphation, etc.
Grease/oil any mechanical moving parts, such as locks and
bolts.
8. KEY COPY
In the case of a safe with a key, if you lose the key you may
request a copy by indicating the serial number of your safe,
which is located on the bottom right of the door.
The V anchor (anchor bolt) is designed to install medium-to-heavy items
using a through hole. V anchors can be used with concrete, natural
stone and dense bricks (with no holes). When adjusting the V anchor
(anchor bolt), remember that the distance between the installation
points and the end of the base have a significant impact on the load. If
these distances are reduced, the load is also reduced.
Installation of the anchor
Parameters for installing V anchors
Dimensions Length
of the anchor of the
(in mm) anchor
(L)
12/140 140
D – Diameter of the drill bit
L – Thickness of the material installed
M – Minimum depth of the perforation
H – Minimum depth of the anchor installation
Diameter Minimum
of the depth of the
drill bit perforation
(D) (M)
12 110
En
Minimum
depth of the
installation
(M)
80