Low Battery Indicator - Arregui IGNUM 41010 Manual De Instrucciones

E. ALARMS FOR WRONG CODE OR IMPACTS
If you introduce a wrong opening code, the screen will indicate "ERROR" and
will give out 3 beeps. After the third consecutive wrong code, the keypad
will automatically become blocked and the alarm will sound for 60 seconds.
If you want the alarm to go off in the case of an impact or movement of the
safe, proceed as follows: after the door is opened, when the display goes
off, press the 0 key; the screen will indicate "BELL ON" and the alarm mode
will be activated.
F. REMINDER OF THE LAST TIMES THE SAFE WAS OPENED
The safe has a device that reminds you of the last 14 times the safe was
opened. The information on the last time that safe was opened can be
seen, as well as the code used to open it.
• Open the safe door by introducing the opening code.
• When "OPEN" disappears from the screen but it is still blue, press the
0 key.
• "PASS1" will appear on the screen and then the date and the time the
safe was last opened, as well as the code that opened it.
• Continue to press the 0 key and the information on the last times the
safe was opened will appear.
G. LOW BATTERY INDICATOR
When the screen indicates "LO-BATTE", the batteries have to be changed
for the safe to function properly.
If the safe is closed, it can be opened in two ways: by using the external
feeder or the emergency key (see section B. OPENING THE SAFE).
To change the batteries, open the compartment at the back of the door
and place 4 1.5V LR6 alkaline batteries (AM3, AA), taking into account their
polarity.
WARNING:
If you do not want the information introduced on the date and time or
the records of the last openings to be deleted, you must change the
batteries of the interior compartment with the external feeder
connector plugged into the front for the electronic circuit to
continue functioning.
<EN>