Intercom - Caberg JUST SPEAK Instrucciones De Uso

3 FUNCTIONS
UK
and connected to the CABERG JUST SPEAK (see paragraph 3.2.1). When the
cellphone is connected to the CABERG JUST SPEAK, the connection is dis-
played on the phone screen. The symbol used varies according to the phone
model (please refer to its instruction manual). The connection is carried out
automatically when the system is switched on. It is, however, possible to con-
nect or disconnect by using the CABERG JUST SPEAK system (see the fol-
lowing table of commands) or the telephone.
Call answer Briefl y press any button when you hear the call
signal.
Disconnect/reject call To interrupt or reject an incoming call, press and
hold
hear the tone. Note: Call rejection, disconnec-
tion and call transfer are not possible on phones
paired in HSP (Headset Profi le).
Voice call To make voice calls (with cellphones that allow
(with phones that
it) or give other voice commands, press and
support this function)
hold button
hear the tone.
Last number recall To recall the last number briefl y press then re-
(with phones that
lease + and - buttons at the same time. The
support this function)
system emits a sequence of tones.
Connect phone To connect the phone or other Bluetooth
press and hold
connection
until the tone.
(HFP profi le)
Disconnect phone To disconnect the phone or other Bluetooth
devices, press and hold + and - buttons for
(HFP profi le)
2 seconds.
(with phones that
support this function)
42
ENGLISH
button for about 2 seconds until you
for about two seconds, until you
®
device
button for about 2 seconds,
Call transfer
(HFP profi le)
Attention: Obey all road traffic laws. Both hands should
be used to control the motorcycle when riding. All opera-
tions on the CABERG JUST SPEAK system should be car-
ried out while the motorcycle is stationary.
3.3 bluetooth ®
To use the CABERG JUST SPEAK as an intercom, both helmets - passen-
ger and driver - must be equipped with a CABERG JUST SPEAK, or similar
compatible device Contact Caberg s.p.A. or your retailer for a list of compat-
ible devices.
For two CABERG JUST SPEAK systems to communicate with each other,
they must first be paired – in other words, they must "meet".
3.3.1 Pairing two CABERG JUST SPEAK kits
• PActivate pairing mode on both CABERG JUST SPEAK systems (starting with
the system turned off, press and hold
rapidly), as described in points 1,2 and 3 of "Pairing with a Bluetooth
cellphone" (paragraph 3.2.1).
• When both systems are in pairing mode, briefly press
met. This must be done for the pairing operation to be completed successfully.
• After a few seconds the CABERG JUST SPEAK systems recognise each
other and a tone signals correct pairing. Intercom communications are now
® enabled.
If the operation is not successful, switch off both CABERG JUST SPEAK sys-
tems and repeat the operation from the start.
To transfer an existing call from the CABERG
JUST SPEAK system to the cellphone, press
and hold + and - buttons at the same time
for 2 seconds.

intercom

button until both LEDs begin to flash
UK
®
enabled
button on rider's hel-
43
ENGLISH