Designation Of The Parts - exonda RDC01 Manual

1 Designation of the Parts

1 Protective cap
2 Cutter head
3 Rotary switch (on/off switch and speed control)
4 Cutting-length lever
5 Side wing (replaceable)
6 Hair clippers
7 Release key
8 Mains plug adapter (replaceable, figure: EURO version)
9 Power unit
10 360° swivel pivot cord
11 2 Velcro® tapes
12 Connector cable
13 Clip
14 Safety button
15 Attachment combs (1.5 mm; 3 mm; 4.5 mm; 6 mm)
16 Serial number (below the cutter head)
Thank you very much
for the purchase of the new professional hair clippers,
the Red Deer No. 1.
During the development of the Red Deer No. 1 the special require-
ments on a professional appliance were taken into account. Whether
in the classical hairdressing salon or in a modern barber shop: these
innovative professional hair clippers reflects the state of the art and
the device's performance will make an impression on you.
The Red Deer No. 1 will adapt optimally to your workflow and support
you with the following features:
• optimal cutting performance
• two speeds
• continuously variable adjustment of the cutting length from 0.5
to 3.5 mm
• 4 attachment combs from 1.5 to 6 mm
• Adjustment of the cutting-length lever for left-handed and right-
handed persons
• 3.5 m long connector cable with a 360° swivel pivot cord
• Clip and Velcro® tape for the connector cable
We are sure you will enjoy working
with the Red Deer No. 1.
ENGLISH 17