What Should I Do If; Technical Specifications - exonda RDC01 Manual

8 What should I do if ...

Problem
... the noise is unusually loud? – The cutter head 2 must be
... the cutter head 2 "plucks"?
... the cutter head 2 turns hot
during use?
... the cutter head 2 still fails to
cut well or is "plucking" af-
ter cleaning and oiling?
... the cutter head 2 is dam-
aged?
... an attachment comb 15 was
damaged?
... the cutting-length lever 4 is
stiff?
Possible causes /
Action
cleaned and oiled (see "Clean-
ing and care" on page 23).
– Check the cutter head for dam-
age.
– Let the cutter head 2 cool down
after the hair cut.
– Ensure regular cleaning and oil-
ing (see "Cleaning and care" on
page 23).
– Check the cutter head 2 for
damage.
– Never use the appliance if the
cutter head 2 is damaged. The
cutter head is a wear part,
which can be reordered (see
"Ordering spare parts" on
page 24).
– Never use a damaged attach-
ment comb 15. Attachment
combs can be reordered (see
"Ordering spare parts" on
page 24).
– The cutter head 2 must be
cleaned and oiled (see "Clean-
ing and care" on page 23).

9 Technical specifications

Product Red Deer No. 1
Model RDC01
Nominal power con-
28 W
sumption
Cutting lengths
(without attachment continuously variable 0.5 - 3.5 mm
comb)
Attachment combs 1.5 mm; 3 mm; 4.5 mm; 6 mm
Dimensions (hand unit)
175 mm x 60 mm x 52 mm
(L x W x H)
Weight (hand unit) approx. 370 g
Length of the connector
3.5 m
cable
Overall weight approx. 680 g
Admissible ambient Temperature: 10 °C - 35 °C
conditions Humidity: 40% - 80% relative humidity
Power unit
Model number ARB2401000V
Type RDC01-A
Input 100 - 240 V ~ 50/60 Hz 1 A
Output 24 V
Protection class II
IP40 (protected against penetration of
Protection type solid bodies with a diameter exceeding
1 mm)
Subject to technical change. The illustrations in these instructions may vary.
1000 mA
ENGLISH 25