Technical Features; Preset Mode Timing Table; Power Saving Function; Troubleshooting - Sun Microsystems GDM-5510 Manual De Instrucciones

Technical Features

Preset mode timing table

When the monitor receives an input signal, it automatically
matches the signal to one of the factory preset modes stored in the
monitor's memory to provide a high quality picture at the center of
the screen. For input signals that do not match one of the factory
preset modes, the digital Multiscan technology of this monitor
ensures that a clear picture appears on the screen for any timing in
the monitor's frequency range (horizontal: 30 – 130 kHz, vertical:
48 – 170 Hz). If the picture is adjusted, the adjustment data is
stored as a user mode and automatically recalled whenever the
same input signal is received.
Preset mode timing table
No. Resolution Horizontal
(dots × lines)
Frequency
1600 × 1200
1 93.750 kHz
1280 × 1024
2 81.130 kHz
1152 × 900
3 71.809 kHz
1280 × 1024
4 79.976 kHz
1280 × 1024
5 71.691 kHz
1152 × 900
6 61.846 kHz
1024 × 768
7 60.023 kHz
1280 × 1024
8 120.941 kHz

Power saving function

This monitor meets the power-saving guidelines set by VESA,
E S
NERGY TAR, and NUTEK. If no signal is input to the
monitor from your computer, the monitor will automatically
reduce power consumption as shown below.
Power mode Power consumption
≤ 135 W
normal
operation
≤ 3 W
active off*
(deep sleep)**
power off Approx. 0 W
* When your computer enters power saving mode, the input signal is cut
and NO SIGNAL appears on the screen before the monitor enters active
off mode. After a few seconds, the monitor enters power saving mode.
**"Deep sleep" is power saving mode defined by the Environmental
Protection Agency.

Troubleshooting

Before contacting technical support, refer to this section.
If thin lines appear on your screen
(damper wires)
The visible lines on your screen especially when the background
screen color is light (usually white), are normal for the Trinitron
monitor. This is not a malfunction. These are shadows from the
damper wires used to stabilize the aperture grille. The aperture
grille is the essential element that makes a Trinitron picture tube
unique by allowing more light to reach the screen, resulting in a
brighter, more detailed picture.
Vertical
Frequency
75 Hz
76 Hz
76 Hz

On-screen messages

75 Hz
67 Hz
If there is something wrong with the input signal, one of the
following messages appears on the screen.
66 Hz
75 Hz
If NO SIGNAL appears in section 1
112 Hz
This indicates that no signal is input from the selected connector.
2 The selected connector
! (power)
indicator
green 3 The remedies
amber
off
15
Damper wires
I NFORMAT I ON
MON I TOR I S WORK I NG
I NPUT 2 : NO S I GNAL
ACT I VATE BY COMPUTER
CHECK S GNAL CABLE I
CHECK I NPUT SELECTOR
This message shows the currently selected connector
(INPUT 1 or INPUT 2).
The following messages appear on the screen.
• If ACTIVATE BY COMPUTER appears on the screen, try
pressing any key on the computer or moving the mouse, and
confirm that your computer's graphics board is completely
seated in the correct bus slot.
• If CHECK SIGNAL CABLE appears on the screen, check
that the monitor is correctly connected to the computer
(page 5).
• If CHECK INPUT SELECTOR appears on the screen, try
changing the input signal (page 6).
EN
W
R
G
B
(continued)