Setup; Step 1: Connect Your Monitor To Your Computer; Step 2: Connect The Power Cord; Step 3: Turn On The Monitor And Computer - Sun Microsystems GDM-5510 Manual De Instrucciones

Setup

This monitor works with platforms running at horizontal
frequencies between 30 and 130 kHz.
Step 1: Connect your monitor to
your computer
Turn off the monitor and computer before connecting.
Notes
• Do not touch the pins of the video signal cable connector as this might
bend the pins.
• When connecting the video signal cable, check the alignment of the
HD15 connector. Do not force the connector in the wrong way or the
pins might bend.
x Connecting to the 13W3 connector
AC IN
To a computer with
a 13W3 video output
x Connecting to the HD15 connector
AC IN
To a computer with
an HD15 video output
2
1
2
1

Step 2: Connect the power cord

With the monitor and computer switched off, first connect the
power cord to the monitor, then connect it to a power outlet.
to AC IN
to a power outlet
power cord
Step 3: Turn on the monitor and
computer
First turn on the monitor, then turn on the computer.
The installation of your monitor is complete.
If necessary, use the monitor's controls to adjust the picture.
If no picture appears on your screen
• Check that the monitor is correctly connected to the computer.
• If NO SIGNAL appears on the screen, try changing the input
signal (page 6), and confirm that your computer's graphics
board is completely seated in the correct bus slot.
• If you are replacing an old monitor with this model and OUT
OF SCAN RANGE appears on the screen, reconnect the old
monitor. Then adjust the computer's graphics board so that the
horizontal frequency is between 30 – 130 kHz and the vertical
frequency is between 48 – 170 Hz.
For more information about the on-screen messages, see "Trouble
symptoms and remedies" on page 17.
5
AC IN
EN