Greenlee 93-105/00408 Manual De Instrucciones página 7

Advanced Features
Relative Mode (REL ∆)
1. Measure a value according to the operating instructions.
2. Press REL ∆. The REL icon will appear. The present value will be used as a reference value
and the display will change to all zeros.
3. Measure a new value. The display will show the difference between the stored reference
value and the present value.
4. Press REL ∆ for two seconds to exit Relative Mode.
When measuring resistance, use the relative mode to use the resistance of the leads as a
reference value. This is the same as "zeroing" an analog meter. Then use the meter
according to the instructions to find the actual resistance value of a resistor or circuit.
MIN MAX
1. Measure a value in autoranging mode according to the operating instructions.
2. Press MIN MAX once and the
the MAX will appear (MIN will disappear). The meter will begin to record the input.
3. (Optional) Press HOLD
HOLD again to resume recording; the display will become active again and the
minimum or maximum value will be updated.
4. Press MIN MAX to exit the MIN MAX mode.
Note: The Auto Power Off feature will shut the meter off after approximately 30 minutes.
Using MIN MAX and Hold: While using the Hold feature, press MIN MAX to go directly into
MIN MAX recording mode.
All manuals and user guides at all-guides.com
and MIN icons will appear; press MIN MAX again and
to stop recording; the display will be held constant. Press
93-105 / 00408
7