Publicidad
Idiomas disponibles
Idiomas disponibles
B5. ADAPTING MICROWAVE BLOWER FOR
OUTSIDE BACK EXHAUST
NOTE: The blower unit exhaust openings should match
exhaust openings on rear of microwave oven.
9. Secure the blower unit to the microwave with the origi
nal screw.
10. Replace the blower plate in the same position as be
fore with the screw. Make sure the screw is tight.
11. Attach the exhaust adaptor to the rear of the oven by
sliding it into the guides at the top center of the back
of the oven.
Adaptor
Guide
Push in securely until it is in the lower locking tabs. Take
care to assure that the damper hinge is installed so that it
is at the top and that the damper swings freely.
B6. MOUNT THE MICROWAVE OVEN
or heat shield during installation. Do not remove the card
board spacers between the heat shield and door.
NOTE: If your cabinet is metal, use the nylon grommet
around the power cord hole to prevent cutting of the cord.
NOTE:
front hangs below the cabinet bottom shelf.
IMPORTANT:
may occur from overtightening screws.
17
Blower Plate
Back of
Microwave
Blower Motor
Screw
Back of
Microwave
Guide
Locking Tabs
NOTE:
microwave oven, thread power
cord through hole in bottom of top
cabinet. Keep it tight throughout
lift oven by pulling cord.
2. Rotate front of oven up
against cabinet bottom.
hole. Temporarily secure the oven by turning the screw
at least two full turns after the threads have engaged.
(It will be completely tightened later.) Be sure to keep
power cord tight. Be careful not to pinch the cord,
net.
Cabinet Front
Cabinet Bottom Shelf
Microwave Oven Top
4. Attach the microwave oven to the top cabinet.
through outer top cabinet
holes. Turn two full turns on
each screw.
EN
1. Lift microwave, tilt it
forward, and hook slots
at back bottom edge
onto four lower tabs of
mounting plate.
Filler Piece
Equivalent to
Depth of Cab
inet Recess
-
Publicidad
