Fluval SIENA 166 Manual De Instrucciones página 3

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 15
READ THOROUGHLY PRIOR TO INSTALLATION AND OPERATION
IMPORTANT: FULLY ASSEMBLE THE CABINET BEFORE REMOVING THE TANK FROM ITS BOX AND NEVER PLACE
THE AQUARIUM ON ANY SURFACE OTHER THAN THE CABINET TO PREVENT DAMAGE TO THE AQUARIUM BASE.
FLUVAL SIENA LED: PARTS
The SIENA Aquarium kit contains two separate packages. Carefully remove all components
from the packaging and make sure that nothing is missing or damaged.
1 package including:
1 x Glass tank (A)
2 x Sliding top covers (B)
2 x LED strip lights (C) + 2 x LED drivers
1 x Plastic bag with:
• 4 x Electrical cable hooks (D)
• 1 x Over rim cable guide (E)
• 2 x Bottom Sealing Plugs (F)
1 x Fluval filter, with its instruction manual
1 x Fluval heater, with its instruction manual
1 package (supplied separately) including:
the disassembled cabinet, with its instruction manual
IMPORTANT SAFETY
INSTRUCTIONS
WARNING: To guard against injury, basic safety precautions
should be observed when handling the LED Strip Lights,
including the following:
1. For the complete enjoyment, use and understanding of this product,
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
and all-important notices on the appliance before using. Failure to do so may result in loss of fish life and/or personal injury or
damage to the unit.
2. DANGER – To avoid possible electrical shock, special care should be taken due to the close proximity of the LED Strip Lights to
water. For each of the following situations, do not attempt repairs yourself; return the appliance to an authorized service facility for
service or discard the appliance. (See Customer Service information at the end of this manual).
If the unit falls into the water, DON'T reach for it! First unplug it and then retrieve it.
If the electrical components of the appliance get wet, unplug the appliance immediately.
Carefully examine the appliance after installation. It should not be plugged
in if there is water on parts not intended to be wet.
Do not operate any appliance if it has a damaged cord or plug, or if it is
malfunctioning, dropped or damaged in any manner. The power cord of the
appliance cannot be replaced; if the cord is damaged, the appliance must be
discarded. Never cut the cord.
To avoid the possibility of the appliance plug or wall socket getting wet, position the
unit to one side of a wall mounted socket to prevent water from dripping onto the
socket or plug. A "drip loop" (see illustration) should be arranged to the socket. The
"drip loop" is that part of the cord below the level of the socket (or the connector if an extension cord is used), to prevent
water travelling along the cord and coming into contact with the wall socket. If the plug or socket does get wet, DON'T
unplug the cord. Disconnect the fuse or circuit breaker that supplies power to the appliance. Then unplug and examine for
presence of water in the wall socket.
3. WARNING - Close supervision is necessary when any appliance is used by or near children. This appliance can be used by children
ages 3 years and above and persons with reduced physical, sensory, or mental capabilities or lack of experience and knowledge
if they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards
involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children without
supervision. This product is not a toy.
4
09611500 SIENA 15L.indd 4-5
09611500 SIENA 15L.indd 4-5
B
E
C
D
C
F
A
4. To avoid injury, do not come into contact with moving parts or hot parts such as heaters, LED devices, etc.
5. CAUTION – Always unplug or disconnect all appliances in the aquarium from electricity supply before placing hands in water,
before putting on or taking off parts and when these LED Strip Lights are being installed, maintained, or handled. Never yank cord
to pull plug from outlet. Grasp the plug and pull to disconnect.
Always unplug an appliance from an outlet when not in use.
WARNING: BE SURE YOU UNPLUG THE LED DRIVER FROM THE POWER OUTLET; JUST SWITCHING OFF THE APPLIANCE
WITH THE APP IS NOT ENOUGH BECAUSE IT DOES NOT STOP THE POWER SUPPLY.
Do not use the appliance for any purpose other than its intended use (i.e. don't use in swimming pools, garden ponds, bathtubs,
etc.). The use of attachments not recommended or sold by the appliance manufacturer may result in a dangerous situation. Do not
try to repair any product component: in case of damage, replace the damaged component with genuine spare parts.
6. IMPORTANT: These LED Strip Lights are AQUARIUM LUMINAIRES suitable FOR INDOOR USE ONLY designed to be assembled onto
Fluval Siena Aquariums only. For fresh and saltwater ornamental aquariums with max 35°C water temperature. Do not install or
store the appliance anywhere where temperatures may drop below freezing.
7. IMPORTANT: Make sure that the LED Strip Lights are securely and correctly installed
before operating. The LED Strip Lights must never operate in water.
Fill the aquarium up to the level indicated on the label situated on the inside of the
aquarium (see the image on the right). IMPORTANT: Do not overfill.
Overfilling the aquarium can cause water to pass under the top frame which then runs down the outside of the
aquarium.
WARNING: Do not plug in the LED Strip Lights if there is water on parts not intended to be wet.
WARNING: Do not place any object(s) on the LED Strip Lights (C) or on the sliding top covers. Ensure sufficient airflow
around the LED Strip Lights. The safety of the appliance is only ensured provided that it has been properly installed.
8. Read and observe all the important notices on the appliance.
9. If an extension cord is necessary, a cord with a proper rating should be used. A cord rated for less amperes or watts than
the appliance rating may overheat. Care should be taken to arrange the cord so that it will not be tripped over or pulled.
SAVE THESE INSTRUCTIONS.
10.
FOR USA ONLY
FCC Statement
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.
Change or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
Consult the dealer or an experienced radio/TV technician for help
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without
restriction.
MAX
5
29/07/21 11:45
29/07/21 11:45

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Siena 272Siena 332Siena

Tabla de contenido