Installation Instructions - Simon, Evers & Co M-532962-PX001 Instrucciones De Manejo

SPECIFICATIONS
Load capacity ......................................200 to 2000kg, depending on springs
Load size ..............................................1.3m wide x 1.3m long x 1.8m high (max.)
Length .................................................1150mm
Width (base frame) ............................930mm
Compressed height............................241mm
Extended height..................................705mm
Rotating ring, outside diameter .....1110mm
Rotating ring, inside diameter .........1030mm
Net weight ...........................................170kg, with (3) springs installed

INSTALLATION INSTRUCTIONS

UNPACKING THE UNIT
1. Before you start to install the unit, check for
local codes and ordinances which may
apply. It is your responsibility to obtain any
necessary permits.
2. Please read all of these instructions carefully.
Be sure to read and understand all of the
warnings.
3. Inspect the shipping pallet carefully for any
damage which may have affected the unit.
If you see signs of damage, tell the trucker.
Also make a note of this on the shipping
papers which you are asked to sign.
4. Choose the place where you want to use the
unit. It is very important that the unit be set
up on a smooth and flat surface. Check the
floor surface carefully and make sure that it
is free of all loose debris and dirt.
SETTING UP AND INSTALLING THE SPRINGS
1. The unit will always have at least one spring.
This spring has an orange mark, and is larger
in diameter than the others. This large orange
spring is always placed in the front of the unit.
Figure 3 shows the position of the first spring.
The frame of the unit can handle loads of up
to 4500 lbs. In order to adapt the unit for
different pallet loads, the springs are changed.
The springs are chosen to match the weight
and height of a fully loaded pallet. A unit may
have one to three springs. Each time the pallet
weight or pallet height is changed, the springs
may also need to be changed. Table 1 shows
how the springs are selected.
2. The unit is shipped without springs installed.
The installation of the first spring (orange)
requires two people. Lift off rotating ring and
both yellow bayonets. Set them aside, they
will be installed later.
F i g . 4
CAUTION!
The unit must be installed on a smooth flat
surface. If the floor is not flat, this can create
stresses in the frame of the unit. The unit may
not work properly, or parts of the unit may
wear more quickly than they should. You may
be hurt or the load may be damaged.
5. Position the unit beside the point where the
unit will be set up.
6. Remove the banding which secures the unit
to the pallet. Remove all packing material.
Shift the unit to the floor. Support the base
as you do this.
7. Check to see that the frame of the unit is
sitting firmly on the floor. Try to move or
rock the frame of the unit. The base frame
Fig. 3
Back
(Hinged End)
3. The shock absorber is attached to the top
frame of the unit with a pivot pin, and this is
held in place by a linch pin. The pivot pin is
used to hold the table frame in the raised
position. Take a look at the mechanism and
note the positions of the parts. Remove the
linch pin and remove the pivot pin. Lay the free
end of the shock absorber down.
F i g . 5
3
should be stable, and should not move.
Check to see that the base frame is level.
8. Remove the springs and lay them out on
the floor.
9. If you have any questions about the steps
in the installation process, please call our
Customer Service.
4. With the help of an assistant, lift the top
Fig. 6
frame until it hits the upper latch stops.
Front
(Roller End)