Simon, Evers & Co M-532962-PX001 Instrucciones De Manejo página 12

5. While holding both latches up, lift the top
frame past the latches until it is at its full,
uppermost position. Have the assistant hold
the weight and insert the pivot pin in the
hole in the base frame. See Fig. 8. With the
unit in this full upper most position the
orange spring can be installed.
Fig. 7
F i g . 8
6. Insert either end of the large orange
spring into the lower pocket. Be sure
the bottom spring coil is positioned
outside the alignment tab as shown.
Fig. 9
Range #1
Fig. 18 Spring Mounting Positions
7. Grasp the spring by the second or third coil
down from the top (DO NOT grasp the top
coil or rung) and push the spring down and
under the edge of the top frame.
Fig. 10
8. While pushing down to compress the spring,
push it forward into the pocket up under the
top frame. It will "snap" into position when
completely in the pocket.
Fig. 11
INCORRECT
Spring not fully
inserted into
13. Figure 18 shows the position of additional springs if needed. Double-check to be sure
you have the correct springs. Refer to Table 1 and see that you have the correct
springs for your application.
Range #2
Fig. 12
CORRECT
Fully inserted into
pocket
Fig. 13
pocket
Range #3
4
9. Remove the shock absorber pivot pin. Push
down on top frame until latches engage.
(Both latches will drop into place).
Fig. 14
10. Reinstall the shock absorber pivot pin and
linch pin.
Fig. 15
11. Install additional springs as needed through
the bayonet openings. Reinsert the yellow
bayonets and twist to lock them in place.
Fig. 16
12. Reinstall the rotator ring.
Fig. 17
Range #4