Tabla de contenido
Publicidad
9
4
B
A
A
10
5
2
12
1
4
6
-32-
Distributed by Volkswagen Zubehör GmbH Printed in Germany by Volkswagen Zubehör GmbH 19.12.2012
9
4
3
5
3
2
1
Figure 4
1. Unfold wheel rails (9) and lock them in position.
Figure 5
1. Unfold rear lights (10) and push them downwards into
their end position.
WARNING
When securing bicycle carrier to vehicle, the rear light
must always be in folded out position. Using the bicycle
carrier with folded rear lights is NOT permitted. The lighting
equipment must also be checked before each journey to
ensure it is in the correct position and it is working correctly.
NOTE
If the vehicle is wider than 1.91 m (max. vehicle width
without exterior mirrors), the rear lights must be moved
outwards.
- To move the lights, push the locking devices (A) together
and move the lights in direction (B).
2. Swing holders (3) and (4) forwards and move them to the
required position on the carrier frame (5).
WARNING
The registration plate on the bicycle carrier must
correspond with the vehicle registration plate and must be
easily readable.
Figure 6
Installing registration plate
1. Press registration plate holder downwards against
springs ( 1 ).
2. Slide registration plate into guides (2) and press against
stop (3).
WARNING
Version for Austria: push stop (3) back. Registration plate
must then subsequently be pushed upwards into guides (2).
NOTE
For narrow registration plates: use drill points (4) to secure
the registration plate.
GB
GB
Publicidad
Tabla de contenido
