Improper Use; Personnel Qualifications - Bosch Rexroth NEXO Serie Manual Del Usuario

26/264 Bosch Rexroth AG
The product is intended for industrial use and not for private use.
The product may be commissioned only after it is has been integrated into the machine/system for which
it is designed and the machine/system fully complies with the EC Machinery Directive. Observe the
operating conditions and performance limits specified in the technical data.
Operation of the product is only permitted in accordance with the national regulations on the
electromagnetic compatibility (EMC) for the respective application.
Only accessories and add-on units that have been approved for use in Rexroth tightening systems may be
used therein. Non-approved components may neither be added nor connected to the system. The same
applies to cables, lines and batteries which belong to the Rexroth Tightening System.
Otherwise, functional and system safety is jeopardized.
Intended use includes having read and understood this documentation and especially the chapter "Safety
instructions".
2.3
Any other use
• than that described in the intended use and
• than that described in the respective documentation is improper and thus not allowed.
Bosch Rexroth AG will not accept any liability for damage caused by improper use. The risks in case of
improper use shall be exclusively borne by the user.
The improper use of the product and its components (if available) includes:
• that it is subjected to operating conditions that do not fulfill the specified ambient conditions; e.g.,
operation is forbidden under water, at high air humidity, under extreme temperature fluctuations, or
under extreme maximum temperatures;
• that it is used in applications that have not been explicitly approved by Bosch Rexroth AG; In this
context, it is absolutely necessary that the safety instructions in the respective documentation be
observed;
• that the structure is modified such that the original state is destroyed;
• the improper programming or configuration of the tightening system.
The user is solely responsible for risks caused by programming and configuring the tightening system.
2.4
Assembly, commissioning, maintenance, troubleshooting and disassembly of this Rexroth product and the
handling of the product require basic electrical and mechanical knowledge, as well as knowledge of the
software and the appropriate technical terms.
In order to ensure the safe use, the specified activities may therefore only be carried out by qualified
technical personnel or an instructed person under the direction and supervision of qualified personnel.
Betriebsanleitung | AB
LSA Control S.L. www.lsa-control.com comercial@lsa-control.com (+34) 960 62 43 01
For instructions on EMC installations, refer to the documentation for the respective component.

Improper use

Personnel qualifications

Nexo | 36088703D0/2014-04