Bosch Rexroth NEXO Serie Manual Del Usuario página 35

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 84
34/264 Bosch Rexroth AG
Pistol grip
The output drive features a standardized quick-change chuck according to DIN/ISO 1173, nominal size
nutrunner
6.3 (1/4"), form E, for mounting the tool bits.
Improper handling!
If the shaft of the attachment tool is not inserted deep enough into the tool mount, it may slip out of the
attachment tool and can no longer be controlled.
Unsuitable attachment tool!
When using tool bits that are too long, high lateral forces are generated which may damage the
product.
– Insert the attachment tool; see page 247 figure 7
– Remove the attachment tool; see page 247 figure 8
8.3
You can choose between different tightening programs that are stored in the hand-held nutrunner.
8.4
With the LED working light you can illuminate the tightening spot when the lighting conditions are poor.
Risk of injury!
Avoid looking into the LED work light unintentionally for a prolonged time period because this might
cause inflammation of the cornea.
The hand-held nutrunner is configured using the NEXO-OS operating system.
8.5
The tightening process is started using the start switch on the hand-held nutrunner.
Releasing the start switch will abort the tightening operation.
The percentage ratio to the nominal torque can be individually configured in the operating program.
Betriebsanleitung | AB
LSA Control S.L. www.lsa-control.com comercial@lsa-control.com (+34) 960 62 43 01
Always ensure that the shaft of the attachment tool fits tightly in the tool mount when inserting tool
bits.
Only use tool bits with a maximum length of 10 cm.
Selecting a tightening program
Changing the program while tightening is in progress will only become active in the next tightening
operation.
Push the program selector to the left or right to select the desired tightening program.
Put the program selector to its center position to lock the hand-held nutrunner (switch lock).
LED working light
Avoid looking directly into the LED work light.
Starting the nutrunner
Keep the start switch pressed until the hand-held nutrunner switches off automatically.
Nexo | 36088703D0/2014-04
NOTE
NOTE
CAUTION

Publicidad

Tabla de contenido
loading

Tabla de contenido