Obd Ii Monitor Readiness Status - Thinkcar THINKTOOL Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 72
www.mythinkcar.com
7) Heated Catalyst
8) A/C system

2.5 OBD II Monitor Readiness Status

OBD II systems must indicate whether or not the vehicle's PCM's monitor system has
completed testing on each component. Components that have been tested will be reported
as "Ready", or "Complete", meaning they have been tested by the OBD II system.
The purpose of recording readiness status is to allow inspectors to determine if the
vehicle's OBD II system has tested all the components and/or systems. The Powertrain
Control Module (PCM) sets a monitor to "Ready" or "Complete" after an appropriate drive
cycle has been performed. The drive cycle that enables a monitor and sets readiness
codes to "Ready" varies for each individual monitor. Once a monitor is set as "Ready"
or "Complete", it will remain in this state. A number of factors, including erasing of
Diagnostic Trouble Codes (DTCs) with a code reader or a disconnected battery, can result
in Readiness Monitors being set to "Not Ready". Since the three continuous monitors
are constantly evaluating, they will be reported as "Ready" all of the time. If testing of a
particular supported non-continuous monitor has not been completed, the monitor status
will be reported as "Not Complete" or "Not Ready."
In order for the OBD monitor system to become ready, the vehicle should be driven under
a variety of normal operating conditions. These operating conditions may include a mix of
highway driving and stop and go, city type driving, and at least one overnight-off period.
For specific information on getting your vehicle's OBD monitor system ready, please
consult your vehicle owner's manual.
Powertrain Control Module (PCM) -- OBD II terminology for the on-board computer that
controls engine and drive train.
Malfunction Indicator Light (MIL) -- Malfunction Indicator Light (Service Engine Soon,
Check Engine) is a term used for the light on the instrument panel. It is to alert the driver
and/or the repair technician that there is a problem with one or more of vehicle's systems
and may cause emissions to exceed federal standards. If the MIL illuminates with a steady
light, it indicates that a problem has been detected and the vehicle should be serviced
vehicle onboard diagnostic system cannot turn the MIL off until the necessary repairs are
completed or the condition no longer exists.
DTC -- Diagnostic Trouble Codes (DTC) that identifies which section of the emission
control system has malfunctioned.
Enabling Criteria
or conditions that must occur within the engine before the various monitors will set, or
10

Publicidad

Tabla de contenido
loading

Tabla de contenido