Plug-In And Plug-Out Of The Diagnostic Cable; Printer Installation - Thinkcar THINKTOOL Manual Del Usuario

www.mythinkcar.com

1.3 Plug-in and Plug-out of the Diagnostic Cable

An aviation connector is used to connect the host and the diagnostic cable. When plugging
in the connector, please note that the red dot of the connector and that of the socket are
aligned. Refer to the following picture:
Tips: Make sure that the red dots are overlapped. Never plug in and plug out it forcefully, otherwise
the pins of the connector may be damaged. As the aviation connector is also used in the endoscope
function module, the plug-in and plug-out operations are the same as those of the diagnostic cable.

1.4 Printer Installation

The printer is installed on the back of the host. Please follow the steps below:
1. Unscrew the backplane screws and remove the host backplane.
2. Insert the host card slot into one side of the printer.
3. Press the buckle on the side of the printer to snap on it into the host.
4. When the host is on, it will automatically identify and connect the printer.
4