Craftsman CMCSTSB970 Manual De Instrucciones página 13

Recommended accessories for use with your tool
are available at extra cost from your local dealer or
authorized service center. If you need assistance in
locating any accessory, please contact CRAFTSMAN, call
1-888-331-4569. Use CRAFTSMAN replacement spool head
Model No. CMZST260H.
Attaching and Adjusting the Shoulder
Strap (Fig. N)
A shoulder strap is recommended for any tool with a total
weight exceeding 13.2 pounds (6 kg) (Total weight includes
the power head, attachment and battery) A shoulder
strap is available at an additional cost from CRAFTSMAN at
1-888-331-4569, part number N769443. Attach the strap to
the tool as shown in Figure N and adjust for proper balance
and support
1. Attach the strap mount.
2. Snap the shoulder strap latch
mount 16 located on the unit, just in front of the ON/
OFF trigger as shown in Fig. N. Adjust the strap so it
fits over your shoulder and provides proper balance
and support.
Fig. N
Replacing Guard (Fig. O, P)
An extended coverage guard is available (sold separately)
for extra coverage if desired. Use CRAFTSMAN replacement
Part Number N712987.

WARNING:
without guard firmly in place. Damage or personal
injury could result.
Remove current guard.
1. Remove the guard screw
2. Slide the guard 8 off.
Assembling the new guard
3. Slide the guard into place as shown in Fig. P.
4. Replace and securely tighten the guard screw
Fig. O
29 onto the strap
16
Never operate appliance
31 shown in Fig. O.
32 .
31
31
Fig. P
31
Versatrack™ (Fig. Q)

WARNING:
serious personal injury, turn unit off and remove
the battery pack before making any adjustments
or removing/installing attachments or
accessories. An accidental start-up can cause injury.

WARNING:
personal injury, do not use a damaged Versatrack™
integral hang hook or Versatrack™ Trackwall. A damaged
Versatrack™ integral hang hook or Versatrack™ Trackwall
will not support the weight of the tool.

WARNING:
29
personal injury, DO NOT suspend tool overhead or
suspend objects from the integral hang hook. ONLY
suspend tool on the Versatrack™ Trackwall using the
integral hang hook.

WARNING:
hang hook is intended to mount the tool onto a
Versatrack™ Trackwall rail. Do not use the integral
hang hook to mount the tool to any other surface.

WARNING:
hang hook is not a belt hook.

WARNING:
Versatrack™ Trackwall rail, adequately space the tools
in order to not exceed 75 lb (35 kg) per linear foot.

WARNING:
sure that the Versatrack™ integral hang hook is
returned to its original position.
NOTICE:
.
CRAFTSMAN provided attachments.
iMPORTAnT: Versatrack™ accessories mount compatible
tools securely to the Versatrack™ Trackwall system.
1. Turn tool off, remove the battery pack and
remove accessories.

CAUTION:
cutting teeth must have them covered securely if it is
8
to be on the Versatrack™ Trackwall.
To reduce the risk of
To reduce the risk of serious
To reduce the risk of serious
The Versatrack™ integral
The Versatrack™ integral
When hanging objects on a
Before using the tool make
Only use VersaTrack™ hook with
Any product with exposed
English
32
11