Ega Master 58888 Manual De Instrucciones página 21

Charging the Battery Pack (See Fig.3)
1. Plug the fast charger into the power source.
2. Slide the battery pack into the charger as the arrow direction shown on the charger.
3. Push the battery pack into place and make sure the red light on the charger is "ON". The
battery pack is now starting the charging cycle.
4. After finish the charging cycle, the light will turn into green. The battery pack is now ready far
use.
5. Your new battery pack is not charged. You need to charge it befare use.
6. Always use the specified charger to charge the battery.
When the battery pack is inserted into the charger correctly, the red light will come on and
charging will begin.
7. When you charge a new battery pack ora battery pack which has not been used far a long
period, it may not accept a full charge. This is a normal condition and does not indicate a
problem. You can recharge the battery pack fully after discharging it completely a couple of
times.
8. Unplug the charger from the power source after finish the charge.
9. Please remove the battery from the unplugged charger far storage.
LED lndication Function
The Battery Pack has a "SW' button and 4-step green LEDs far indicating remaining capacity
status.
The fuel gauge green LED will indicate within 3 seconds when the "SW" button is
momentarily pressed.
Remaining Capacity LED lndication
LED 1 (green)
LED 1, 2 (green)
LED 1, 2, 3 (green)
LED 1, 2, 3, 4 (green)
Fig.3
RC Status
0%- 25%
26%-50%
51%-75%
76%-100%
21