Cleaning Instructions - 3M DBI SALA DELTA Manual Del Usuario

5.0 MAINTENANCE, SERVICING, STORAGE
5.1 CLEANING INSTRUCTIONS: Clean the Delta Full Body Harness as follows:
1. Spot clean the harness with water and a mild soap solution.
;
Use a bleach-free detergent when washing the harness and pads. Fabric softener or dryer sheets SHOULD NOT be used when
laundering and drying the harness and pads.
2. Water temperature for wash and rinse must not exceed 160° F (70° C).
3. The harness and pads may be air dried or tumble dried on low heat not exceeding 200° F (90° C).
;
More information on cleaning is available from 3M. If you have questions concerning the condition of your harness, or have any
doubt about putting it into service, contact 3M.
5.2 AUTHORIZED SERVICE: Additional maintenance and servicing procedures must be completed by a factory authorized
service center. Authorization must be in writing. Do not attempt to disassemble the unit.
5.3 STORAGE AND TRANSPORT: Store and transport the Delta Full Body Harness in a cool, dry, clean environment out of
direct sunlight. Avoid areas where chemical vapors may exist. Thoroughly inspect the harness after extended storage.
6.0 LABELING:
Figure 15 illustrates product labels and their location on the Delta Full Body Harness. All labeling must be present and
fully legible.
24