universalblue USBANO2000-18 Manual De Instrucciones página 20

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

 If the power cord is damaged, it must be replaced by the
manufacturer or a service agent or a qualified person to
avoid a hazard.
 Do not hang anything on the heater while it is running.
 Do not place the appliance near a radiant heat source.
 Do not use the appliance to dry clothes.
 Do not insert or allow the entry of foreign objects into any
ventilation or exhaust opening, as this could cause electric
shock, fire or damage to the appliance.
 Use this appliance only as described in this manual. Any
other use is not recommended by the manufacturer and may
cause fire, electric shock or injury.
 The most common cause of overheating are deposits of dust
or lint on the device. Be sure to frequently remove these
deposits by sucking the vent hole. To do this, unplug the
appliance before carrying out any task.
 Do not use abrasive cleaning products on this appliance.
Wipe with a damp cloth (hot wet) rinsed with hot water and
soap only. Always disconnected from the network before
cleaning.
 The appliance becomes slightly hot when in use. To avoid
burns, do not allow bare skin to touch hot surfaces.
 The use of an extension cord with this device is not
recommended.
 Do not allow the cable to come into contact with hot surfaces
during operation.
 The heater must be installed at least 0.2 m below the ceiling
and 2 meters above the ground.
 The heater must not be installed near curtains and other
combustible materials.
 During use, do not open the door or window continuously,
otherwise it will influence the heating effect.
 If you want to turn off the appliance, press the on / off switch
to turn it off. The heater will keep the fan running for 30
seconds until the wind blows cool, then the appliance will
turn off.
20

Publicidad

Tabla de contenido
loading

Tabla de contenido