Operating The Appliance - universalblue USBANO2000-18 Manual De Instrucciones

3. OPERATING THE APPLIANCE

Connect the device to a source of 220-240 V, 50 Hz, AC. Press the
power switch on the back and the LED display will show the room
temperature, then use the remote control or the button on the
control panel to start the appliance.
Standby mode display:
Please, note these are the buttons included in your appliance:
ON/ OFF HEAT
 Press the
remote control once. The display will show
low temperature wind will blow.
button on the heater control panel or on the
icon and the
23