Remote Control Device Installation - TOHATSU MFS 9.9E Serie Manual Del Propietário

22
INSTALLATION
PT type
1. To attach the outboard motor to the
boat, use the bolts to secure the out-
board motor brackets on transom
board.
5
2
3
1. Bolt (8 × 85)
2. Washer (small diameter)
3. Nut
4. Washer (large diameter)
a. 30 - 63 mm
View A
ENOW00008-A
CAUTION
Mounting bolts should be installed with
the bolt head at inside surface of the
All manuals and user guides at all-guides.com
1
A
4
5
a
ENOF00308-1
194
152
187
193
ENOF00305-0
transom. Mounting bolts installed with
the threaded end at the inside surface of
the transom can cause personal injury.
Tighten the bolts sufficiency, otherwise
falling down of outboard could be hap-
pened.
ENON00003-A
Notes
1. Apply sealing material, such as silicone
sealed between the bolts and the tran-
som board holes before tightening the
bolts.
2. Be sure to tighten the mounting bolt
nuts to the specified torque.
(30 N·m (3.0 kgf·m) 13 ft·lb)
ENOM00840-0
2. Remote control device
installation
ENOW00100-B
CAUTION
Be careful not to loop the remote control
cables to a diameter of 406 mm (16 in) or
less. Otherwise, it affects the durability of
the cable.
ENOW00850-0
Remote control box location
1. Shift cable
2. Throttle cable
3. Cable harness B
3
1, 2
ENOF00841-0