Start-Up And Use; Using The Hob; Using The Oven - Hotpoint Ariston CP65SP2/HA Manual De Instrucciones

Start-up and use

Using the hob

GB
Lighting the burners
For each BURNER knob there is a complete ring
showing the strength of the flame for the relevant
burner.
To light one of the burners on the hob:
1. Bring a flame or gas lighter close to the burner.
2. Press the BURNER knob and turn it in an
anticlockwise direction so that it is pointing to the
maximum flame setting E.
3. Adjust the intensity of the flame to the desired
level by turning the BURNER knob in an
anticlockwise direction. This may be the minimum
setting C, the maximum setting E or any position in
between the two.
extinguished when the knob is released. If this
occurs, repeat the process, holding the knob down
for a longer period of time.
! If the flame is accidentally extinguished, switch off
the burner and wait for at least 1 minute before
attempting to relight it.
If the appliance is equipped with a flame failure
safety device*, press and hold the BURNER knob
for approximately 2-3 seconds to keep the flame
alight and to activate the device.
To switch the burner off, turn the knob until it
reaches the stop position •.
Practical advice on using the burners
For the burners to work in the most efficient way
possible and in order to save on the amount of gas
consumed, it is recommended that only pans which
have a lid and a flat base are used. They should
also be suited to the size of the burner.
To identify the type of burner, please refer to the
diagrams contained in the "Burner and nozzle
specifications".
20
If the appliance is fitted with
an electronic lighting device*
( see figure ), press the
BURNER knob and turn it in
an anticlockwise direction,
towards the minimum flame
setting, until the burner is lit.
The burner might be
Burner
Fast (R)
Semi Fast (S)
Auxiliary (A)
Triple Crown (TC)
! Make sure the pans do not overlap the edges of
the hob while it is being used.
! For models equipped with a reducer grid, the latter
must be used only for the auxiliary burner, when
pans with a diameter of less than 12 cm are used.
WARNING! The glass lid can break in if it is
heated up. Turn off all the burners and the electric
plates before closing the lid. Applies to the models
with glass cover only.

Using the oven

! Before operating the product, remove all plastic
film from the sides of the appliance.
! The first time you use your appliance, heat the
empty oven with its door closed at its maximum
temperature for at least half and hour. Ensure that
the room is well ventilated before switching the oven
off and opening the oven door. The appliance may
emit a slightly unpleasant odour caused by
protective substances used during the
manufacturing process burning away.
1. Select the desired cooking mode by turning
the SELECTOR knob.
2. Select the desired temperature with the
THERMOSTAT knob. See the Cooking advice table
for cooking modes and the suggested cooking
temperatures ( see Cooking Modes ).
3. When lit, the THERMOSTAT indicator light
indicates that the oven is heating up to the
temperature set.
Ø Cookware Diameter (cm)
24 - 26
16 - 20
10 - 14
24 - 26