Publicidad
1
INSERT THE BOLTS INTO THE AWNING TRACK.
With the awning on a stable surface, insert 2 bolts on each side into each of
the tracks. Slide the bolts toward the center (as shown in step 1 on page 2).
2
ATTACH THE BRACKETS.
=
Using a tape measure, measure the distance
between your crossbars. This measurement is your
M4. Place the brackets over the bolts you inserted
in step 1 being sure to orient the brackets relative
to the zipper as pictured. Using a 13 mm wrench,
install 2 thin washers and 2 nuts as shown. Set
the distance between the center of the brackets
to your M4 measurement, and measure to make
sure the pair of brackets are centered on the
awning. Tighten completely to 9 Nm ±1.
3
INSERT THE NUT PLATES.
Insert 2 nut plates into each crossbar.
Instruction #1036150A - page 6 of 11
ASSEMBLY - HD BAR LOW AND HIGH POSITION
M4
HIGH POSITION
POSITION HAUTE
POSICIÓN ALTA
zipper
glissière
cremallera
LOW POSITION
POSITION BASSE
POSICIÓN BAJA
=
2X
Publicidad
