Chapter 6: Windows Millennium Installation And Setup; Overview; Windows Millenniumdriver Installation - Linksys USB200M Guia Del Usuario

Chapter 6: Windows Millennium
Installation and Setup

Overview

After physically connecting the Adapter to your computer's USB port or hub,
follow these instructions to install the hardware device driver. The installation
procedure for the hardware device driver may vary slightly depending on your
current system configuration. If at any time during the installation you
encounter problems, consult "Appendix A: Troubleshooting."
Windows Millennium Driver Installation
1. If you haven't already, start your computer.
2. Windows Millennium will automatically detect the Adapter connected to
your PC. When the Add New Hardware Wizard screen appears, insert the
Driver CD into your CD-ROM drive, and select Specify the location of the
driver (Advanced). Click the Next button.
Note: Throughout this guide, it is assumed that "D" is the letter of
your CD-ROM drive.
14
Instant EtherFast
Figure 6-1
® Series Compact USB 2.0 10/100 Network Adapter
3. Select Search for the best driver for your device (Recommended). You
MUST remove the checkmark from the box next to Removable Media.
Select Specify a location:, and enter D:\winME in the field provided. Then
click the Next button.
4. When Windows notifies you that it is ready to install the driver files, click
the Next button to continue.
Note: Do not click Cancel at any time during the installation
process. Doing so will prevent your driver from being properly
installed on your PC.
Figure 6-2
Figure 6-3
15