Site Preparation; Opening Dimensions; Electrical Requirements - Sub-Zero Designer Serie Guia De Instalacion

Site Preparation

Opening Dimensions

DESIGNER MODELS
635 mm
OPENING
DEPTH
654 mm
FOR OUTDOOR
MODEL
TOP VIEW
H W
OPENING
OPENING WIDTH
HEIGHT
SIDE VIEW FRONT VIEW
NOTE: 89 mm finished returns will be visible and should be finished to match cabinetry—
114 mm for outdoor model.
19 mm 19 mm
TYPICAL TYPICAL
89 mm 89 mm
FINISHED FINISHED FILLER
RETURN RETURN
W W
FRAMELESS FRAMED
CABINETRY CABINETRY
OPENING DIMENSIONS
COLUMN / TALL W*
457 mm Column 457 mm 2134 mm
610 mm Column 610 mm 2134 mm
762 mm Column / Tall 762 mm 2134 mm
914 mm Column / Tall 914 mm 2134 mm
DRAWER W*
610 mm Drawer 610 mm
762 mm Drawer 762 mm
914 mm Drawer 914 mm
The depth of each designer model is 610 mm. Allow for
panel thickness when planning the finished opening depth.
A minimum 89 mm finished return is required on all sides
of the opening—114 mm for the outdoor model. Framed
cabinets require additional finished filler material behind
the face frame for a proper installation. Refer to the illus-
tration.
DUAL INSTALLATION
When installing two units side by side in a dual installa-
tion, the opening width is the width of the two units added
together. A dual installation kit is required for this installa-
tion. If a dual installation kit is not specified, a minimum
51 mm filler strip is required between the units.
Dual installation kits are available through an authorized
Sub-Zero dealer.

Electrical Requirements

Installation must comply with all applicable electrical
codes and be properly grounded (earthed).
H
The electrical supply must be located within the shaded
area shown in the illustration and chart below. A separate
circuit servicing only this appliance is required.
IMPORTANT NOTE: For indoor models, a ground fault cir-
H
cuit interrupter (GFCI) is not recommended and may cause
876 mm
interruption of operation. For the outdoor model, a ground
876 mm
fault circuit interrupter (GFCI) is required to reduce the risk
876 mm
of electrical shock.
The electrical outlet must be positioned with the ground-
ing prong to the right of the thinner blades.
ELECTRICAL SUPPLY LOCATION
457 mm Model
610 mm Model
762 mm Model
914 mm Model
LEFT SIDE
OF OPENING
114 A
mm
108
mm
FLOOR
6 mm
Electrical supply location
ELECTRICAL REQUIREMENTS
Electrical Supply 220-240 V AC, 50/60 Hz
Service
Receptacle grounding-type (earthed)
A
152 mm
241 mm
318 mm
394 mm
10 amp
subzero.com | 3