Completion - Sub-Zero Designer Serie Guia De Instalacion

Installation

Completion

DOOR TRIM INSTALLATION
After the panels have been adjusted, install the decorative
side trim to the door/drawers. To install, start at the top
and align the trim with the front and rear flanges on the
bracket, then snap into place by pushing the trim toward
the back of the panel. Once the top is secure, continue the
installation downward until the remaining trim is com-
pletely secure. Refer to the illustrations below.
SIDE TRIM
FRONT
FLANGE
REAR
FLANGE
Door side trim Bracket flanges
SIDE TRIM INSTALLATION
Install the decorative trim strip to the handle side of tall
and column models. The side trim snaps over the bracket
attached to the handle side of the unit. Refer to the illustra-
tion below.
Side trim
KICKPLATE INSTALLATION
Position the kickplate and install using the two mounting
screws. Refer to the illustration below. The kickplate must
be removable for service. The floor cannot interfere with
removal.
For indoor models, a maximum 152 mm decorative kick-
plate can be attached to the factory-installed kickplate.
The two rows of vented louvers can be covered if the
door panel is a minimum 102 mm from the finished floor.
A decorative kickplate cannot be attached to the outdoor
model.
To install a decorative kickplate, remove the paper backing
from the magnets and attach the decorative kickplate to
the magnets. The magnets allow the decorative kickplate
to be removed if necessary.
Turn power on by touching "power" on the control panel.
MAGNET SCREW
Kickplate installation
90° DOOR STOP
A 105° door stop is built into the hinges of tall and column
models. To limit the door swing to 90°, open the door
slightly less than 90°, then use a standard screwdriver
blade to remove the existing clips from each hinge. Locate
the 90° clips from inside the plastic bag containing the
product literature, then insert the 90° clips onto each
hinge. Refer to the illustration below.
CLIP
90° door stop
subzero.com | 9