Publicidad
Idiomas disponibles
Idiomas disponibles
DOME PROGRAMMING:
To access the domes menus, there are two possibilities:
1. For systems set up for 485 control or with Sprite systems dating from mid-2004 onwards,
configured for Dennard C coax control, press the * key twice and a message will appear
on the screen saying, "To enter the menu press enter button".
2. For older systems using coax control, the following key presses are used:
For the Operator menu press:
For the Supervisor menu press:
For the Technician menu press:
The Operator menu will then be displayed enabling you to navigate around the menus using the
joystick to move the cursor and pressing the 'enter' key to accept menu options.
6.1.2 RS485 control
The controller telemetry must be configured as follows:-
Dennard Serial telemetry. This is set up in the System Options menu of the Sprite 2 and then
selected in the Alarms and Presets menu.
Each Dome must be individually addressed
(Refer to the Operation/Installation Manual, supplied with each Dome, for an explanation on access
to, and setting of, the address switches)
RS485 connection from the Sprite 2 is via a 9-way D type female connector and the connection is
as follows:
Domes are, by default, supplied with termination resistors fitted. These will need to be removed
from all but the last dome in the Daisy chain.
6.2 Baxall / Vista controllers
Up the coax control
The controller telemetry must be configured as follows:-
1: Rx attached, needs to be set to DC
2: Telemetry mode, needs to be set to STANDARD
The Dome address switches need to be set to BAX DC PANEL
(Refer to the Operation/Installation Manual, supplied with each Dome, for an explanation on access
to, and setting of, the address switches)
Blue rotary address switch set to F.... Yellow rotary address switch set to E.
Dennard 2040 / 2060 Menu System Manual
All manuals and user guides at all-guides.com
pin 1 = data A =yellow wire from dome
pin 9 = data B =green wire from dome
* 8 8 9 10 10 2
* 8 8 9 10 10 3
* 8 8 9 10 10 4
Page. 32
Publicidad
Capítulos
