Dennard Dtx400/Dc - Dedicated Micros Dennard 2040 Manual

All manuals and user guides at all-guides.com
When you have finished entering text close the menu by moving the cursor down to the 'Accept
entry' line and accept by pressing and holding the 'preset' key, then pressing key number 1.
DOME PROGRAMMING:
To access the dome menu:
Press and hold the # key then press the 'wash' key.
This will give you access to the operator menu. The Supervisor menu and Technicians menu can
be accessed from this point. Holding the 'preset' key, then pressing key number 1 is used to
enter/accept.

6.5 Dennard dtx400/dc

Up the coax control
The controller telemetry will output BBV protocols
The Dome address switches need to be set to DEN PANEL
(Refer to the Operation/Installation Manual, supplied with each Dome, for an explanation on access
to, and setting of, the address switches)
Blue rotary address switch set to F.... Yellow rotary address switch set to D.
This is the default setting for domes unless specified otherwise.
NB If the dome is supplied with a remote protocol converter in the PSU box, then the
address switches will be factory set to: Yellow = 1 Blue = 0
STORING PRESET POSITIONS:
Note that, in this configuration, it may be quicker to use the Dennard controller software
rather than using the Dome software.
Move the camera to desired position.
Press and hold the 'Set' key then press the number key you want to use to identify the preset.
(Note that only eight preset positions can be set using this controller.) At this stage the preset menu
from the dome will be displayed on the screen enabling you to key in a preset identification. If you
don't want to add a preset identification, move the cursor down to the 'Accept entry' line and accept
by pressing key number 1. Text can be entered by moving the cursor under each letter/number in
turn, using the joystick, and then pressing key number 1 to accept.
When you have finished entering text, close the menu by moving the cursor down to the 'Accept
entry' line and accept by pressing key number 1.
DOME PROGRAMMING:
To access the dome menu:
Press and hold the 'shift' key then press No 1 key
This will give you access to the Operator menu. The Supervisor menu and Technicians menu can
be accessed from this point. The number 1 key is used to enter/accept.
Dennard 2040 / 2060 Menu System Manual Page. 35