Dennard Dtx1000/Dc - Dedicated Micros Dennard 2040 Manual

All manuals and user guides at all-guides.com
STORING PRESET POSITIONS:
Note that, in this configuration, it is quicker to use the Baxall controller software rather than
using the Dome software.
To programme a preset via the controller, enable the TELEMETRY, CAMERA and WIPE keys.
Move the camera to the desired position.
Press the function key and enter the preset number using the number keys, then press the preset
key. At this stage the preset menu from the dome will be displayed on the screen enabling you to
key in a preset identification. If you don't want to add a preset identification, move the cursor down
to the 'Accept entry' line and accept by pressing the WASH key. Text can be entered by moving the
cursor under each letter/number in turn, using the joystick, and then pressing the WASH key to
accept.
When you have finished entering text close the menu by moving the cursor down to the 'Accept
entry' line and accept by pressing the WASH key. Once the presets have been stored, switch off the
'CAMERA' and 'WIPE' functions for normal operation.
DOME PROGRAMMING:
Access to the dome menu can be achieved by enabling the TELEMETRY, CAMERA and WIPE
buttons then pressing & holding the preset key, pressing & holding key 6 then release the preset
key then key 6. This will give you access to the operator menu. The Supervisor menu and
Technicians menu can be accessed from this menu. The WASH button is used to enter/accept.

6.3 Dennard dtx1000/dc

Up the coax control
The controller telemetry will output BBV protocols.
The Dome address switches need to be set to DEN PANEL.
(Refer to the Operation/Installation Manual, supplied with each Dome, for an explanation on access
to, and setting of, the address switches)
Blue rotary address switch set to F.... Yellow rotary address switch set to D.
This is the default setting for the domes unless specified otherwise. If the dome is supplied with a
remote protocol converter in the PSU box, then the address switches will be factory set to:
Yellow = 1 Blue = 0
STORING PRESET POSITIONS:
Notes:
In this configuration, it may be quicker to use the controller software rather than using the
Dome software
The Dennard dtx1000 uses on screen menu display which is only available if the monitor is
connected to the keyboard. Simple programming options, like setting a preset position, can
be programmed in without the ability to see the menu display.
Dennard 2040 / 2060 Menu System Manual Page. 33