Inserting The Filter; Keep-Warm Function - Beem CLASSIC SELECTION CJ-656B Manual De Instrucciones

27

Inserting the Filter

1. If you have not already done so, insert the fi lter insert into the coffee tank (2).
2. Insert the permanent fi lter or a basket fi lter paper into the fi lter insert.
3. Close the lid (1).
Basket fi lter papers are available via our website www.beem.de or from our customer service
department on request.
Setting the Brew Strength
The strength of the coffee varies depending on the amount of water and coffee. To ensure
that with little water you get a coffee that is not too bitter and with a lot of water you still get
a strong coffee, the device has two settings which can be used to infl uence the brew strength.
These can be selected using the BRÜHSTÄRKE (brew strength) button (1). The chosen
setting is shown on the display (10):
STARK (strong)
1 – 4 TASSEN (cups)
A normal brewing time is preset (similar to other coffee machines).
The brew strength MUST be set before starting the brewing process. The setting cannot
be changed during the brewing process. If no option has been selected, the coffee
machine brews in normal mode (presetting).

Keep-Warm Function

The device has a keep-warm function (1 – 4 hours), which can be set using the WARM-
HALTEN (keep warm)
The keep-warm function is preset to 4 hours. The following settings can be selected:
0 – Iced coffee (see the "Preparation" chapter – "Making Iced Coffee")
1 – The coffee is kept warm for 1 hour after the end of the brewing process
2 – The coffee is kept warm for 2 hours after the end of the brewing process
3 – The coffee is kept warm for 3 hours after the end of the brewing process
4 – The coffee is kept warm for 4 hours after the end of the brewing process
1. Prepare the coffee machine for making coffee with coffee powder (see the "Preparation"
chapter).
2. Keep pressing the WARMHALTEN (keep warm) button until the setting you want (0 – 4)
appears on the display (10).
3. Start the brewing process (see the "Preparation" chapter). The hotplate remains switched
on as per the chosen setting after the end of the brewing process.
This setting can be adjusted before, during or after the brewing process.
4. To end the keep-warm function prematurely, press the START / STOPP (start / stop)
button (16).
03840_DE-EN-FR-ES-IT_Inlay_A5_V3.indb 27 03840_DE-EN-FR-ES-IT_Inlay_A5_V3.indb 27
Strong coffee with lots of water (longer brewing time)
Normal, aromatic coffee with little water (shorter brewing time)
button (12).
EN
16.01.2019 09:44:22 16.01.2019 09:44:22