Publicidad
Idiomas disponibles
Idiomas disponibles
7.
Tighten the LATCH/UAS strap.
Press down firmly in the center
of the car seat while tightening
the LATCH/UAS strap. You
may need to tighten further by
pulling upwards in-line with the
belt path as shown.
8. Test for tightness.
Grab the side of the seat with
one hand where the LATCH/
UAS strap is and slide the car
seat side-to-side and front-
to-back. If the seat moves
less than 1 in. (2.5 cm), it is
tight enough. Do not test by
grasping the top or back of the
seat.
9. To remove LATCH/UAS strap
from vehicle — Use LATCH/
UAS release on the LATCH/UAS
connectors and pull them off
the anchor bars.
36
radian 3RX
8 7
1. Place car seat rear-facing in
9 8
2. Slide the vehicle seat belt
10 9
INSTALL USING LAP/SHOULDER BELT WITH
5-POINT HARNESS : 5–50 lb (2.3–22.7 kg)
back seat of the vehicle with
detachable rear-facing base
installed (page 31). The entire
seat bottom should sit flat on
the vehicle seat.
through the rear-facing belt
path and out the other side.
Buckle it. The seat belt should
lie flat and not be twisted.
diono.com
1
2
37
Publicidad
