Publicidad
Idiomas disponibles
Idiomas disponibles
HARNESS STRAP REMOVE/REPLACE
1. Remove harness straps from the
metal hook on back of seat.
2. Pull the harness straps out from the
back of the seat. Remove the harness
pads and chest clip from each side.
Slide the harness strap out of the
buckle tongues.
3. Using a Phillips head screwdriver, take
out the screws and remove the access
panel. Remove old harness straps
from each side of the seat.
4. Insert new harness strap through the
slot and pull the strap up.
5. Once the strap is pulled up until the
metal "D" ring is located as shown,
re-fasten and close the access panels.
6. Slide the new harness straps through
the buckle tongues, re-attach the chest
clip and reinstall the harness pads.
7.
Slide the harness straps through to the
back of the seat and re-install them to
the metal hook in Step 1.
66
radian 3RX
WARNING:
with ELR (Emergency Locking Retractor) that does
not switch to function as an ALR (Automatic Locking
Retractor), you MUST use a locking clip to secure lap
portion of vehicle seat belt. If you have any questions,
1
please consult your vehicle owner's manual or contact
the vehicle manufacturer.
1. Remove lock clip from back of
seat.
2
2. Route the vehicle seat belt
through the proper belt path
and buckle it in. While pushing
down on seat, pin the two straps
3
together behind the buckle
tongue. Unbuckle the belt without
allowing it to slip.
3. Attach locking clip to lap/
shoulder belt as shown. Re-
4
buckle belt. Check that lap belt
does not move by pulling hard. If
belt loosens or lengthens, repeat
procedure.
5
BELT LOCKING CLIP
If your vehicle lap/shoulder belt is equipped
diono.com
1
2
3
67
Publicidad
