Self-Learning - Sagola PACK 6000X Manual De Instrucciones

36/37
Then follow the next steps:
- Press "SEL" for 3 seconds ("dSP1 0040" appears on the display).
- Press "SEL" again so that the display flashes.
- Press the down arrow until the value 0077 is set.
- Press "SEL" again so that the display stops flashing.
- Press the down arrow ("dSP2" appears on the display).
Repeat the operation 14 times with the values marked in the table below:
Symbol Display
DSP1
DSP1
DSP2
DSP2
DSP3
DSP3
DSP4
DSP4
DSP5
DSP5
DSP6
DSP6
DSP7
DSP7
DSP8
DSP8
DSP9
DSP9
DP10
DP10
DP11
DP11
DP12
DP12
DP13
DP13
DP14
DP14
- Once the values have been modified, press "SEL" for 2 seconds to return to the temperature
display mode.

10.3.- Self-learning

Consult with the SAGOLA S.A.T. before carrying out any operation that
modifies the default parameters set in the Controller.
To carry out any modification you must make sure that the minimum
air consumption during the whole process must be at least 150 L/
min.
Factory default
Program
0040 0077
00E0 00E4
0060 00F0
002C 00A8
0014 009C
0001 00FF
0000 00FF
0000 00FF
0000 009F
004E 00FF
00bE 00FF
00FF 00FF
0007 014F
0007 014F
ENGLISH
Locked
00FF
00E4
00FE
00FF
00FF
00FF
00FF
00FF
00FF
00FF
00FF
00FF
017F
07F