Master/Slave Mode; Dmx Mode - HQ-Power VDPL300CB Manual Del Usuario

From To
A61 A69
A71 A79
So1 So1
So2 So2
7.3

Master/slave mode

The master/slave mode allows for connecting several devices to a single master device. All slave devices
then work synchronously with the master device.
You need to set one device to master mode and all other devices to slave mode.
1. Connect all devices in series with DMX cables.
2. The first unit in the chain functions as the master fixture. Set up the unit as described in Stand-
alone mode.
3. On each of the connected slave units, set the DMX starting address to <A001> as follows: press
<MENU> until <A001> is displayed and press <ENTER>. Use <UP> and <DOWN> to select
<A001> and press <ENTER>.
4. Repeat for each slave unit.
7.4

DMX mode

This mode allows you to control the fixture by any universal DMX controller.
•
All DMX-controlled devices need a digital start address so that the correct device responds to the
signals. This digital start address is the channel number from which the device starts to "listen" to
the DMX controller. The same starting address can be used for a whole group of devices or an
individual address can be set for every device.
•
When all devices have the same address, all the units will "listen" to the control signal on one
particular channel. In other words: changing the settings of one channel will affect all devices
simultaneously. If you set individual addresses, each device will "listen" to a separate channel
number. Changing the settings of one channel will only affect the device in question.
•
In case of the 6-channel VDPL300CB, you will have to set the start address of the first unit to 1
(CH1~6), the second to 7 (1 + 6) (CH7~12), the third to 13 (7 + 6) (CH13~18), and so on.
To set the device to work with a DMX controller:
1. Press <MENU> until <A001> is displayed and press <ENTER>.
2. Use <UP> or <DOWN> to set the DMX starting address (A001 ~ A512) and press <ENTER>.
DMX channel values
Channel From
0
1
6
0
2
1
0
3
1
0
4
1
0
5 5
128
0
6 6
251
V. 01 – 05/07/2012
All manuals and user guides at all-guides.com
VDPL300CB
Description
Fade in and out, motor rotates from fast to slow
Strobe mode, motor rotates from fast to slow
Sound control, coloured lights and rotation
Sound control, white light and rotation
To Description
5 Switch
255 Strobe from fast to slow
0 Red off
255 Gradual change from dark to light
0 Green off
255 Gradual change from dark to light
0 Blue off
255 Gradual change from dark to light
5 Motor stop
127 Motor is turning
255 Motor reverse
5 Start up CH1-CH5
250 Built-in program, CH1-CH5 off
255 Sound control
6 ©Velleman nv