Quick Start Guide - GBC MFPP-C1 Manual De Instrucciones De Operación

3. QUICK START GUIDE

MFPP-C1 must be connected to AC power to enable any feature of
the machine.
Some Canon printers may not have Crease modes selectable from
the printer menu. For these printers, only Single Punch and Double
Punch options are visible on the job creation menu. For these
printers, simply select Single Punch or Double punch (either option
can be used interchangeably) on the printer menu when setting up
the Crease job, and select the desired mode on the MFPP-C1 User
Interface. The machine will now function in the mode selected on
the MFPP-C1 User Interface.
A. Bypass Mode:
This operation will allow paper to pass through the MFPP-C1
without being punched.
This is the default mode of operation for MFPP-C1. MFPP-C1
will operate in Bypass mode when no punch option is selected.
B. Punch Modes: When a punch die is inserted
To configure the Die Set for the desired sheet size that is being
processed see section 8 – Die Set User Manual.
i) Single Punch Mode:
This operation will punch the trail edge of all sheets that pass
through the MFPP-C1. A properly configured die set must be
inserted before running single punch mode. See section 4. A for
details on Die set changes and follow the labels on the die set for
configuration. Select Single Punch on the printer job setup menu.
ii) Double Punch Mode:
This operation will punch two rows of holes- One in the middle
of the sheet and the other adjacent to the trail edge of all sheets
that pass through the MFPP-C1. A properly configured die set
must be inserted before running punch mode. See section 4. A for
details on Die set changes and follow the labels on the die set for
configuration. Select Double Punch on the printer job setup menu.
iii) Saddle Punch Mode:
This operation will punch the two rows of holes- One just before
the center of the sheet and the other the same distance after the
center of the sheet. A properly configured die set must be inserted
before running punch mode. See section 4. A for details on Die
set changes and follow the labels on the die set for configuration.
Select Double Punch on the printer job setup menu. Select Saddle
Punch on the settings menu of MFPP-C1.
C. Crease Modes: When a Crease die is inserted
i) Center Crease Mode:
This operation will apply a crease in the center of all the sheets that
pass through the MFPP-C1. The crease die set must be inserted
before running center crease mode. Select Center Crease from the
Settings menu on MFPP-C1.
ii) Book Crease Mode:
This operation will apply 2 creases around the center of all the
sheets that pass through the MFPP-C1. These crease positions
can be adjusted to increase the width of the book spine and its
position from the center. The crease die set must be inserted before
running book crease mode. Select Book Crease from the Settings
menu on MFPP-C1.
iii) C-Fold Crease Mode:
This operation will apply 2 creases spaced at 1/3 and 2/3 from the
trail edge of the sheet. These crease positions can be adjusted to
ensure the sheet will lay flat when folded. The crease die set must
be inserted before running C-Fold crease mode. Select C-Fold
Crease from the settings menu on MFPP-C1.
MFPP-C1
GB
5