Problem Solving; Specifications - GBC MFPP-C1 Manual De Instrucciones De Operación

6. PROBLEM SOLVING

Problem
No power, won't punch
Punched holes not aligned
with the edge of the paper
Sheet jamming repeatedly
at die set area.
Error code when reading
die
Full cover (9"x11" or 223 x
297mm) does not have the
punched holes lined up
with Letter or A4 paper.
Insert Chip tray message
on the LCD interface.
Probable Cause
Power cord not attached to back of
machine or not properly plugged into
the wall.
Follow instructions on die set labels
to properly configure the die for a
specific sheet size.
Remove the die-set, inspect the die
throat to see if there is any stuck
paper chad.
Check that printed sheets do not have
excess curl. Make efforts to reduce
curl to the minimum possible. Review
the printer manual to reduce this if
present.
Check the die chip is not dirty or worn.
Check that the Full Bleed setting is set
to Tab/Full Cover not Full Bleed.
Make sure the Chip tray is fully
inserted.

7. SPECIFICATIONS

Speed Up to 144 sheets per minute
Paper Weight Plain: 75gsm - 300gsm
(20# bond to 110# cover)
Coated: 120gsm - 300gsm
(32# bond to 110# cover)
Clear cover: 7mil unprinted
Bypass mode 350mm x 1260mm (13" x 49.6")
450gsm
Punch Capacity Single Sheet
Power Supply
115V, 60Hz, Single Phase
230V, 50Hz, Single Phase
Electrical Amps and
Frequency
Safety Certification cTUVus
Dimensions
L: 745mm; W: 445mm; H: 1100mm
L: 29.3"; W: 17.5"; H: 43.3"
Weight 96 kg
212 lbs
Shipping Weight 127 kg
280 lbs.
Manufactured Assembled in Taiwan
MFPP-C1
Polypropylene stocks should not be used
115V; 4.2A; 60Hz (or)
230V; 2.1A; 50Hz
GB
9