User Operations - GBC MFPP-C1 Manual De Instrucciones De Operación

4. USER OPERATIONS

A. Interchanging Die Sets:
Are completed without tools and only take seconds to perform
B. Punch Chip Container:
Easy-to-access chip tray for quick chip disposal
C. Die Set Storage:
Holds up to 2 spare Die Sets
D. Bypass:
Short straight-through paper path for unpunched documents
E. Punch/Crease Mode Path:
Wide radius turn can support stocks up to 300g/m
Paper flow and User Interactive sections of MFPP-C1
A.
Your MFPP-C1 offers the convenience of interchangeable die sets,
allowing you to economically punch or creasete documents for a wide
variety of binding styles and applications. Changing the die sets is both
quick and easy, as the following instructions illustrate:
Note: For advanced Die Set Configuration instructions- See Section 8
Die Set User Manual.
Removing Die Sets from the Machine: The inter-changeable die set
slot of the MFPP-C1 is located above the Punch Chip container at the
bottom of the punch.
cover
2
Please note that when using a new die punch some oil will be present
around the punched holes on the sheet. After punching 25 to 50 sheets
the die will no longer leave oil on the sheets. It is recommended that a
short test job be run after installing a new die or a die that has recently
been oiled to remove the residual oil.
B.
The Punch Chip Container for your MFPP-C1 is located at the front of
the machine's base. The drawer should periodically be pulled out and
emptied. The MFPP-C1 uses a sensor to determine when the punch
container is full. Once the punch container becomes full the LCD display
shows "Chip Tray Full" message.
Interchanging Die Sets:
Step 1: Stop the feeder.
Step 2: Open the MFPP-C1 access door panel.
Step 3: Securely grasp the die lock handle and rotate it in the CCW
direction, as indicated in the label near the die lock handle. This
releases the die from the locked position.
Step 4: Slide the die set out until it is fully removed, supporting
it with both hands. Take care not to let the die identification chip
(located on the underside at the rear end) drop onto the die stop as
it leaves the machine.
Step 5: Properly store the removed Die Set in the Die Set storage
area. (keep away from dust, dirt, and possible accidental falls from
the edge of counters, etc.).
Step 6: Select the desired Die Set for your new job and slide it into
the Die Set slot. Push the Die set firmly until the Die stop feature
contacts the round magnet. This is critical in ensuring the proper
position of the die set.
Step 7: Grasp the handle and rotate it in CW direction until the latch
is fully engaged, as shown indicated in the label.
WARNING: POSSIBLE PINCH POINT HAZARD. WHEN
INSTALLING DIE SETS IN YOUR MFPP-C1, ALWAYS
KEEP FINGERS AND OTHER BODY PARTS OUT OF
THE MACHINE'S DIE SET SLOT AND AWAY FROM ALL
AREAS OF THE DIE SET. FAILURE TO FOLLOW THESE
PRECAUTIONS MAY RESULT IN INJURY.
Step 8: Close the Access Door Panel.
Step 9: Proceed with your job.
Punch Chip Container:
MFPP-C1
GB
6