Publicidad
Idiomas disponibles
Idiomas disponibles
C.
Paper Clearing:
When paper is jammed in the paper path of
MFPP-C1 the LCD display shows the area where
a sheet(s) is jammed.
Area
If paper is jammed in Zone 1, lift the paper guide
plate located just inside, reach and remove the
jammed paper. To close the paper guide, raise
the handle to unlatch the mechanism and firmly
close it.
If paper is jammed in Zone 2, move the door to the
right, reach in and remove the jammed paper.
If paper is jammed in Zone 3, press the top lever
while holding the bottom lever. This will unlatch the
chute; continue to open the chute until it reached
the magnet on the right side. Reach in and remove
the paper. To return the chute to the closed
position, move it back in the opposite direction until
the latch mechanism is activated.
If paper is jammed in Zone 5, unlatch the chute,
reach in and remove any jammed paper.
If paper is jammed in Zone 6, move the door to the
left, reach in and remove the jammed paper.
Before uninstalling the die set, ensure Zone 3 and
5 are cleared of any jammed paper. If there is no
paper found in Zone 3 and 5, then uninstall the die
set to remove any jammed paper. (see Section 4,
Changing the Interchangeable die sets)
Description
5. USER DISPLAY OPERATION CONTROLS
The MFPP-C1 has a touch screen interactive LCD panel that provides
messages, settings, and information relating to the functions of the
punch unit.
Settings
Punch or Crease
die inserted
Punch die inserted
Mode
Alignment
Crease die inserted
Crease Mode
Center Crease
Book Crease
Select
Adjustment
Adjustment
LCD Panel Overview
Messages on the LCD Panel
1.
Ready
MFPP-C1 is ready to run the selected mode.
2.
Running
MFPP-C1 is running in the selected mode operation.
3.
Chip tray Full
When the punch container becomes full of wastepaper chips, this
message will be displayed.
4.
Chip tray Out
When the punch container is removed or not fully inserted into the
punch unit, this message will be displayed.
5.
Check die
When the Die Set is removed or not fully inserted into the punch unit,
this message will be displayed. When this message is displayed the
punch unit will run in Bypass mode only.
6.
Close Door
When the Front door is open or not completely closed this message
will be displayed.
7.
Paper jam
When a sheet of paper becomes jammed within the punch unit, this
message is displayed. See the section of this manual titled PAPER
CLEARING for instructions on how to remove a jammed sheet.
MFPP-C1
Home
Info
Backgage
Clear Cover
Language & Units
C-Fold Crease
Language & Units
Adjustment
GB
7
Publicidad
