Mopar 82212502 Instrucciones De Montaje página 15

71. Prepare to crimp/splice the backup camera power wire
(PK/OR) to the (DB/PK) of the 12V ignition power out­
let wiring harness connector as follows:
a. Cut the 12V ignition power outlet DB/PK wire.
b. Remove 13 mm (0.5 in.) of insulation from each
wire that needs to be spliced.
c. Place a piece of adhesive lined heat shrink tubing
(2) on one side of the wire. Make sure the tubing
will be long enough to cover and seal the entire
repair area.
d. Place the strands of wire overlapping each other
inside of the splice clip (1).
72. Using crimping tool (1), Mopar® p/n 05019912AA or
equivalent, crimp the splice clip and wires together.
Jun 30, 2011
All manuals and user guides at all-guides.com
15
K6861197