Publicidad
Idiomas disponibles
Idiomas disponibles
INITIAL INSTALLATION
3. Check to make sure blades (I) are at least 30 in. from
any obstruction and at least 7 ft. above the floor. (Fig. 3)
4. Loosen canopy mounting screws (FF) in
slotted holes in canopy (B) and remove the
other two screws (FF)--save screws (FF) for
later use. Remove mounting bracket (C) from
canopy (B). (Fig. 4A) Secure mounting bracket
(C) to outlet box using screws, spring washers,
and flat washers provided with the outlet box.
(Fig. 4B)
*Note: It is very important that you use the
proper hardware when installing the mounting
bracket (C) as this will support the fan.
Important: If using the angle mount, make
sure open end of mounting bracket (C) is
installed facing the higher point of the ceiling.
5. Remove motor screws (AA) and lock washers
(CC) from underside of motor and save for blade
arm (H) attachment later on. [If there are plastic
motor blocks installed with the motor screws (AA)
and lock washers (CC), discard the plastic motor
blocks.] (Fig. 5)
Follow mounting instructions on page 8 and or 9
depending on mounting method (A or B) chosen in
Step 2 on previous page.
All manuals and user guides at all-guides.com
7
7 ft.
min.
Fig. 4A
C
FF
Hardware Used
FF
Canopy Mounting Screw
Hardware Used
Motor Screw
AA
CC
5.4 M/M Lock Washer
Fig. 3
I
30 in.
min.
Fig. 4B
FF
C
B
Fig. 5
AA
CC
E
x 10
x 10
C
x 4
Publicidad
