Publicidad
Idiomas disponibles
Idiomas disponibles
FINAL INSTALLATION
5. Punch center cap out of switch housing cap (F)
with a screwdriver. (Fig. 5A)
Remove hex nut (II) and lock washer (JJ) from
threaded rod at top of light kit fitter (K). Remove
finial (M), finial plate (L) and white washer from
threaded rod at bottom of light kit fitter (K). (Fig. 5B)
Save hex nut (II), lock washer (JJ), finial (M), finial
plate (L) and white washer for later use.
6. Gently feed wires from light kit fitter (K) through
center hole in switch housing cap (F). Screw switch
housing cap (F) onto threaded rod on light kit fitter
(K) followed by lock washer (JJ) and hex nut (II).
Tighten hex nut (II) over lock washer (JJ) for a
secure fit. (Fig. 6)
Connect WHITE wire from light kit fitter (K) to WHITE
wire from switch housing. Connect BLACK wire from
light kit fitter (K) to BLUE wire from switch housing.
(Fig. 6) Make sure that molex connections are
secure.
7. To attach light kit fitter (K) to fan, align holes in
switch housing cap (F) with holes in switch housing.
[Note: Make sure to align gap on top edge of the
switch housing cap (F) with the reverse switch on
switch housing for the correct fit.] Re-insert the
screws (and star washers) that were removed in
Step 4 on previous page and use a Phillips
screwdriver to secure all screws. (Fig. 7)
8. Install three candelabra base 60 watt max. bulbs
(N) included. (Fig. 8)
Important: When you need to replace bulbs, please
allow bulbs and glass shade (G) to cool down before
handling them.
All manuals and user guides at all-guides.com
14
Fig. 5A
Fig. 5B
F
JJ
Center
Cap
L
Hardware Used
Hex Nut
II
JJ
Lock Washer
Fig. 6
Switch
Housing
JJ
F
Fig. 7
Screw and
Star Washer
Fig. 8
E
II
K
White
Washer
M
x 1
x 1
Molex
Connections
II
K
Switch
Housing
F
K
N
Publicidad
