Waeco PerfectView CAM26W Instrucciones De Montaje Y De Servicio página 43

Collected_RV-HD-Compact_Q4
Please note the following points:
– Install the cable, depending on the possibility, always in the interior of the vehicle.
There it is better protected than outside the vehicle. If you, however, install the cable
outside the vehicle, pay attention that there is a safe attachment (by additional cable
clips, insulating tape etc.).
– In order to avoid damage to the cable, keep always sufficient distance to overheated
and moving vehicle parts (exhaust pipes, driving shafts, generators, ventilators etc.)
when installing cables.
– Wrap each connection at the cable (also in the vehicle) tightly with a good
insulating-tape.
– Pay attention when installing the cable that these:
1. are not sharply bent and twisted,
2. do not rub at the edges,
3. are not laid through sharp-edged openings.
– Each breakthrough at the skin must be protected by appropriate measures against the
inrush of underground water, e.g. through inserting of the cable with sealing
compound and by washing off the cable and the bushing with sealing compound.
Begin with the sealing of the openings only after all adjustment work at the camera is
concluded and the required lengths of the connecting cables are determined.
Use for the sealing of the plug connector the attached or a comparable
self-vulcanizing seal strip.
Tip: In order to minimize corrosion in the plug, we recommend you to apply
some grease, e.g. pole fat into one of the plugs.
Use of the branch connectors
In order to avoid loose contacts at the branch connections, it is important that the cable
cross-sections fit the branch connectors. Working steps for the use of the branch
connector:
1. Lay the cable that is to be extracted into the front groove of the branch connector
(see H 1).
2. The new cable lies with the end at approx.
3. Close the connector and press the metal seam with the combination pliers into the
connector, so that a current connector can be produced (see H 3).
4. Press the protective cap down and let it engage at the connector. Check the attach-
ment of the branch connection by pulling on the cable (see H 4).
Providing correct soldered joints
In order to connect a cable to original lines:
1. insulate 10 mm from the original line (see H 5),
2. insulate 15 mm of the cable that is to be connected (see H 6), .
3. then wrap the cable that is to be connected around the original line and solder (see H 7),
4. insulate cable with insulating tape (see H 8).
30/06/03 11:00
All manuals and user guides at all-guides.com
Laying the cables
Page 43
3
/ in the rear groove (see H 2).
4
43