Types Of Work - Hilti TE 60-AVR Manual De Instrucciones

All manuals and user guides at all-guides.com
5.1.2 Fitting the depth gauge (optional)
1. Release the side handle clamping band by turning the handle grip.
2. Slide the depth gauge from the front into the 2 guide holes provided.
3. Tighten the side handle clamping band by turning the handle grip.
5.1.3 Setting the power level (optional)
TE 60-ATC/AVR
1. Press the power reduction button. The product runs with reduced power (50%).
◁ The reduced-power LED lights.
2. Press the power reduction button again. The product runs with full power.
◁ The reduced-power LED goes out.
Note
After connecting the supply cord to the electric supply, the product is always set to full power.
5.1.4 Changing the accessory tool
WARNING
Risk of injury! The tool becomes hot as a result of use.
▶ Wear protective gloves when changing the tool.
1. Apply a little grease to the connection end of the accessory tool.
2. Push the accessory tool into the chuck as far as it will go (until it engages).
◁ The product is ready for use.
3. Pull the chuck back as far as it will go and remove the accessory tool.
Note
Use only the recommended grease supplied by Hilti. Use of unsuitable grease may cause damage
to the product.

5.2 Types of work

CAUTION
Risk of injury! Loss of control over the combihammer.
▶ Check that the side handle is fitted correctly and tightened securely. Check that the clamping
band is engaged in the groove provided on the tool.
Observe the safety instructions and warnings in this documentation and on the product.
5.2.1 Drilling with hammering action (hammer drilling)
Note
To set the power tool to reduced (50%) drilling power, press the reduced-power button. The drilling
power LED then lights. To reselect full drilling power, press the reduced-power button again.
1. Set the function selector switch to the "Hammer drilling" position
2. Press the drill bit against the work surface.
3. Press the control switch.
◁ The product starts.
4
5
6
7
.
19