Denon AVC-A1SR Instrucciones De Operación página 16

ENGLISH
NOTES:
• The OPTICAL 5 and 6 jacks on the AVC-A1SR's rear panel are equipped with an optical digital output jack
for recording digital signals on a DAT deck, MD recorder or other digital recorder. Use this for digital
recording between a digital audio source (stereo - 2 channel) and a digital audio recorder.
• Do not connect the output of the component connected to the OPTICAL 5 OUT jack on the AVC-A1SR's
rear panel to any jack other than the OPTICAL 5 IN jack.
• Do not connect the output of the component connected to the OPTICAL 6 OUT jack on the AVC-A1SR's
rear panel to any jack other than the OPTICAL 6 IN jack.
• "PHONO" cannot be selected on the Digital In Assignment screen.
Setting the Video Input Mode
• Select the input signal to be output from the video monitor output terminal. (See page 41 for details.)
1
At the System Setup Menu select "Video Input Mode".
2
Switch to the Video Input Mode screen.
3
q Select the input source for which you
want to set the Video Input Mode.
AUTO: When there are multiple input signals, the input signals are detected and the input signal to
be output from the video monitor output terminal is selected automatically in the following
order: component video, S-Video, composite video.
Component: The signal connected to the component video terminal is always played.
Video conversion is not conducted, so no image is output from the monitor output terminal
when there is no input signal to the component terminal.
Only DVD, TV or DBS can be selected.
S-Video: The signal connected to the S-Video terminal is always played.
The S-Video input signal is up-converted and output from the component monitor output
terminal.
Video: The signal connected to the composite video terminal is always played.
The composite video input signal is up-converted and output from the S-Video and
component monitor output terminals.
NOTE:
Down-converting from the component video signal to the S-Video and composite video signal is not
possible, so when not using the component video monitor output terminal connect the player using the
S-Video or composite video input terminal.
4
Enter the setting.
The System Setup Menu reappears.
16
Setting the Audio Delay
This function allows you to adjust the time delay of the video and audio signals and store these settings for the
different input sources.
The setting is made while watching a DVD or other software, so it is not made here.
By default, this is not displayed when no digital signals are being input.
For instructions on making the setting, refer to page 29.
Setting the Multi Zone Control
The AVC-A1SR is equipped with two sets of multi-zone outputs.
Multi-zone1 is a pre-output with an output level adjustment function.
Multi-zone2 is a fixed output level pre-output. Using the power amplifier assignment function described below,
it is also possible to connect speakers to the SB/MULTI speaker terminals.
[1] Setting the multi-zone1 vol. level
1
2
w Select the mode.
3
4
Select the desired setting, then press jog stick "ENTER".
Variable:
The level can be adjusted freely using the buttons on the remote control
unit (M. ZONE1 4/5, VOLUME UP and VOLUME DOWN).
-40 dB, 0 dB:
The output level is fixed at the set level and the volume can no longer be
adjusted.
At the System Setup Menu, select "Multi Zone Control".
Press jog stick "ENTER" to switch to the "Multi Zone
Control" screen.
Select "Multi Zone1 Vol. Level" then press jog stick "ENTER".